Operating Instructions; Operating The Ez-Link System - Ryobi 750r Operator's Manual

OPERATING THE EZ-LINK™ SYSTEM
The EZ-Link™ system enables the use of these optional
Add-Ons:
Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . BV720r
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . HS720r
Snow Thrower . . . . . . . . . . . . . . . . . . . . . . . . . . . ST720r
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . SS725r
Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TP720r
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r
WARNING: Read and understand the
operator's manual for each add-on prior to
operation.
Removing the Cutting Attachment or Add-Ons
1. Turn the knob counterclockwise to loosen (Fig. 19).
2. Press and hold the release button (Fig. 19).
3. While firmly holding the upper shaft housing, pull
the cutting attachment or add-on straight out of the
EZ-Link™ coupler (Fig. 20).
WARNING: To avoid serious personal injury
and damage to the unit, shut off the unit
before removing or installing add-ons.
Installing the Cutting Attachment or Add-On
NOTE: Place the unit on the ground or on a work bench
to make add-on installation or removal easier.
1. Turn knob counterclockwise to loosen (Fig. 19).
EZ-Link™ Coupler
Knob
Fig. 19

OPERATING INSTRUCTIONS

Release Button
Guide Recess
2. While firmly holding the add-on, push it straight into
the EZ-Link™ coupler (Fig. 20).
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 19).
EZ-Link™ Coupler
Primary Hole
Upper Shaft Housing
3. Turn the knob clockwise to tighten (Fig. 21).
CAUTION: Lock the release button in the
primary hole and securely tighten the knob
before operating this unit
90˚ Edging Hole
(Trimmer Only)
CAUTION:
The cutting attachment and add-
ons with the EZ-Link™ system are to be used in
the primary hole unless stated otherwise in the
specific add-ons operator's manual. Using the
wrong hole could lead to personal injury or
damage to the unit.
For edging (when using the line head cutting attachment
with EZ-Link™ models), lock the release button of the
cutting attachment into the 90° edging hole or the 180°
edging hole (Fig. 21).
Release Button
Lower Shaft Housing
Fig. 20
180˚ Edging Hole
(Trimmer Only)
Knob
Fig. 21
13