Ryobi CFS1501 Operator's Manual page 12

CHANGING THE SANDING SHEETS
See Figure 8.
The sander is packed with sanding sheets and pads designed
for a variety of uses. To change sheets, simply pull the used
sheet off the base and attach the desired sheet by pressing
the sheet or pad onto the base of the sander.
PAPER PUNCH
See Figure 9.
A paper punch template has been supplied with your sander
for aligning and punching holes in sandpaper. The punched
holes must align with the holes in the sander cushion.
■ Install sandpaper on your sander.
■ Align sander cushion over the paper punch. See Figure 9.
■ Push down on the sander.
OPERATION
ROTATING THE SANDING SHEETS
See Figure 10.
The majority of wear in a precision sanding application oc-
curs at the tip of the sanding sheet. The unique Tri-Flex de-
sign of the sanding sheets and scrubbing pads allows you to
detach and rotate the top two thirds of each and extend the
life of the pad or sheet.
To rotate the top of the pad or sheet, simply remove the top
two thirds along the perforation. Rotate the pad or sheet so
that a clean corner is located at the tip of the base. Press the
pad or sheet firmly onto the pad.
Fig. 8
Fig. 9
Page 12
Fig. 10