Your new router mounting kit has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual.
Always use the saw's master switch to turn the router ON and OFF. NEVER USE A ROUTER BIT larger in diameter than the opening in the router mounting plate.
Page 4
RULES FOR SAFE OPERATION The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger.
NOTE: This router kit has been specifically designed for use with Ryobi Routers Only. The hole pattern on the mounting plate has not been drilled to accommodate other routers. WARNING: Attempting to assemble the Router Mounting kit or...
3/4 in. KNOB BOLT 5/16 in. T-NUTS POST SPACER Your #4950301 Router Mounting Kit includes the following parts: DESCRIPTION Guide Fence Bracket with Guide Block ... 2 Knob Bolt (5/16-18 x 1/2 in. for Guide Fence) ... 4 5/16 in. Washer ... 5 5/16 in.
Failure to do so could result in serious injury. IMPORTANT This router kit has been specifically designed for use with Ryobi Routers. The hole pattern on the mounting plate has not been drilled to accommodate other routers. NOTE: Mounting screws for Ryobi routers, model numbers R160, R161, R165, RE170, RE170VS, R175, RE175, R180, RE185, RE600, and RE601 are provided in this kit.
Page 8
TO ASSEMBLE ROUTERS WITH 2-HOLE PATTERN TO ROUTER MOUNTING PLATE: See Figures 5 and 6. For Ryobi routers, model numbers R175, RE175, and RE180PL. NOTE: Models R175 and RE180PL must also use #4830175 depth control kit.
Page 9
See Figure 6 . TO ASSEMBLE ROUTERS WITH 3-HOLE PATTERN TO ROUTER MOUNTING PLATE: See Figures 7 and 8. For Ryobi routers, model numbers R160, R161, R165, RE170, RE170VS, R180, and RE185. Unplug the router. WARNING: Unplug the router to avoid possible injury.
TO ASSEMBLE ROUTERS WITH 4-HOLE PATTERN TO ROUTER MOUNTING PLATE: See Figures 9 and 10. For Ryobi routers, model numbers RE600 and RE601. Unplug the router. WARNING: Unplug the router to avoid possible injury. Make sure the router switch is OFF and the router is not connected to a power source.
Select the correct size throat plate for the size of the router bit. Align the tab on the throat plate with the slot in the accessory table and snap in place. Make sure the throat plate is firmly seated below the table surface.
The infeed fence should be adjusted to support the uncut workpiece while the outfeed fence should be adjusted to properly support the workpiece after the cut passes the router bit, compensating for the removed stock. ROUTER MOUNTING DIRECTION OF FEED IS FROM RIGHT TO LEFT...
Page 15
4950301 ROUTER MOUNTING KIT Now that you have purchased your Router Mounting Kit, should a need ever exist for repair parts or service, simply contact your nearest Ryobi Authorized Service Center. Be sure to provide all pertinent facts when you call or visit.
WARRANTY Ryobi warrants its accessories for a period of 90 days from the date of purchase. Batteries and chargers are warranted for a period of two years from the date of purchase. PARTS AND SERVICE For parts or service, contact your nearest Ryobi authorized service center. Be sure to provide all relevant information when you call or visit.