Operation - Ryobi RY52504 Operator's Manual

OPERATION

POSITION FOR STARTINg
See Figure 9.
PRIMER BULB
Lay the pruner on the ground and ensure that no objects or
obstructions are in the immediate vicinity. Make sure nothing
can come in contact with the bar and chain.
STARTER
GRIP
ENGINE
SwITCH
Fig. 9
STARTING
INSTRUCTION
STARTINg AND STOPPINg
LABEL
See Figures 10 - 12.
To start a cold engine:
DO NOT squeeze the throttle trigger until the engine starts
THROTTLE
and runs.
TRIGGER
 Lay the trimmer on a flat, bare surface.
 PRIME - Press the primer bulb 7 times.
 SET the start lever to the START position.
Fig. 11
 PULL the rope until the engine starts.
 Allow the engine to run for 6-10 seconds.
 Squeeze trigger lock and throttle trigger.
NOTE: Squeezing and releasing the throttle trigger releases
the start lever to the RUN position.
To start a warm engine:
PULL the rope until the engine starts.
To stop the engine:
Press and hold the switch in the stop " " position until the
engine stops.
START
ENGINE
SwITCH
TRIGGER
LOCK
RUN
THROTTLE
TRIGGER
Fig. 10 Fig. 1
13