Advertisement
TO UNFOLD STROLLER:
DO NOT allow children near stroller while unfolding.
1. Release the folding latch located on the right side.
2. Lift up on the stroller handle with both hands making sure the
stroller frame is erect and locks in the open position. (Fig. 7)
The stroller has spring-loaded latches on both sides of the
frame. Test that both latches are fully engaged prior to placing
your child in the stroller.
3. Extend the front frame by rotating it forward. (Fig. 8b). Slide the
two plastic fittings forward and then back so both latch securely
onto the front tubes of the stroller frame. (Fig. 8a)
TO ATTACH AN INFANT CAR SEAT:
1. Place car seats onto snap bars with stroller open and locked in
place. (Fig. 9) Please refer to the chart on next page for snap bars'
positions. (Fig. 12) NOTE: Some brands of infant car seats will
lock onto the snap bar, and some brands may simply rest on the
bar,
you must ALWAYS
seat that is placed on the Snap-N-Go.
2. Strap the safety belt over the carseat and connect the buckles
together. Tighten the strap so the car seat fits snug and can't
move. (Fig. 10) NOTE: Some car seats have slots for the safety
belt to slide through, if you have a car seat with these slots
please feed the safety belt through each slot and secure. (Fig. 11)
WARNING:
from falling, ALWAYS use the safety belt to
secure both of FRONT and REAR car seats.
Fig. 10
IF YOU EXPERIENCE ANY DIFFICULTY IN USING THIS PRODUCT,
PLEASE CONTACT OUR CUSTOMER SER VICE DEPARTMENT
AT (800) 328-7 363 BETWEEN THE HOURS OF 8:00AM AND 4:30PM
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
use the safety belt to secure every car
Avoid serious injury
Fig. 11
PA CIFIC STANDARD TIME FOR ASSISTANCE.
Fig. 7
Fig. 8a
Fig. 8b
Fig. 9
5
Advertisement
