Setup; Part Names And Functions; Led Indicator; Setup Overview - Panasonic KX-HNS101 Installation Manual

Setup

Part names and
functions
n Sensor unit
A
Sensor unit cover
M
Used to confirm the status of the
sensor or register the sensor to
the hub.

LED indicator

Magnet unit cover
" " marks
Used to align the sensor and the
magnet unit when installing them
(page 11).
8
HNS101_(en_en)_0616_ver.130.pdf
n Magnet unit
E E
B
C
N
For assistance, please visit http://shop.panasonic.com/support
8
LED indicator
You can press M
LED indicator to confirm the sensor's
status.
Indicator Status
Green, lit Window/door is closed
D
Red, lit Window/door is open
Red, Sensor is out of range
blinking of the hub
Green, Registration mode
blinking (You pressed and held
slowly M
Off No battery power
Note:
R The LED indicator does not indicate
sensor status if the sensor has not
been registered (page 9).

Setup overview

1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the battery
The window/door sensor is battery
powered.
3
Registration
Required only if the window/door
sensor was purchased separately
(i.e., not as part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
N and check the
N)
2015/06/16 22:24:10