Table of Contents
Advertisement
INSTALLER
INSTALLATION MENU
9. KEY FUNCTION (f) –
(KeyFn)
10. SAVE CHANGES? (f) –
(Save?)
LEARN IR (LrnIR)
This procedure allows IR commands to be learned into the system and be centrally stored in the main
controller to let the system access the same IR codes that operate the source equipment.
NOTE: IR codes must be learned in by pointing the remote at the CAM6.6's REAR panel IR receiver
only. See Learn IR - Flow Chart on page 73
1. LEARNED SRC –
(LnSrc)
2. KEY FUNCTION –
(KeyFn)
3. LEARN/DELETE –
(Ln/Dl)
4. TEST IR? –
(TstIR)
5. SUCCESS? -
(OK?)
MACRO EDITOR (MacEd)
This procedure is used to create a sequence of commands that are launched with one key touch or
other event. Up to 132 macros can be created for the system, and each macro can contain up to 10
60
Select Keypad function.
Select "yes" to save the changes.
Select the source (Source 1-6 and Miscellaneous Learned IR
(Misc)) whose commands will be learned into the controller.
Select the function to be learned or deleted.
Select Learn IR Now or Delete IR. If Learn IR Now, a "USE
REMOTE" prompt appears. Point the learning remote at the
controller's IR window. If Delete IR, procedure returns to
LEARNED SRC (step 1)
If "yes," sends the learned command to the source component
to test the IR. If the component responds, the IR test was a
success. If the component does not respond the Code was not
learned properly. If "no," menu goes back to LEARNED SRC
(step 1)
Asks if the IR test was a success
IF YES - If the test was a success, specify "yes" and proceed to
KEY FUNCTION (step 2)
IF NO - If the test was a failure, specify "no" and LEARN/DELETE
(step 3) reappears on the display allowing another code to be
learned in.
Advertisement
Table of Contents
