Oven Vent; Baking And Roasting; Broiling - Kenmore 664.9512 Series Use & Care Manual

Oven Vent

A
The oven vent releases hot air and moisture from the oven
and should not be blocked or covered. Blocking or covering
the oven vent will cause poor air circulation, affecting cooking
and cleaning results. Do not set plastics, paper, or other items
that could melt or burn near the oven vent.

Baking and Roasting

NOTE: The convection fan will shut off when the oven door
is opened. If the oven door remains open for too long, the
heating elements will shut off until the oven door is closed.
All timers, including any active Cook Time or Timed Cook
functions, will continue to count down.
Preheating
When beginning a Bake, Convect Bake, or Convect Roast
cycle, the oven will begin preheating after Start is pressed.
The oven will take approximately 12 to 15 minutes to reach
350°F (177°C) with all of the oven racks provided with your
oven inside the oven cavity. Higher temperatures will take
longer to preheat. The preheat cycle rapidly increases the
oven temperature. The actual oven temperature will go above
your set temperature to offset the heat lost when your oven
door is opened to insert food. This ensures that when you
place your food in the oven, the oven will begin at the proper
temperature. Insert your food when the preheat tone sounds.
Do not open the door during preheat before the tone sounds.
Rapid Preheat
Rapid Preheat can be used to shorten the preheating time.
Only one standard flat oven rack should be in the oven
during Rapid Preheat. Extra racks should be removed prior to
starting Rapid Preheat. Press RAPID PREHEAT and follow the
oven control prompts, or, if preheating has already started,
simply press RAPID PREHEAT. The preheating cycle should be
completed before placing food in the oven. When the Rapid
Preheat cycle is complete, the oven starts a normal Bake cycle.
IMPORTANT: Rapid Preheat should be used only for
one-rack baking.
Oven Temperature
While in use, the oven elements will cycle on and off as
needed to maintain a consistent temperature, but they may
run slightly hot or cool at any point in time due to this cycling.
Opening the oven door while in use will release the hot air
and cool the oven which could impact the cooking time and
performance. It is recommended to use the oven light to
monitor cooking progress.
NOTE: On models with convection, the convection fan
may run in the non-convection Bake mode to improve oven
performance.
18
A. Oven vent
Temperature Management System
The Temperature Management System electronically regulates
the oven heat levels during preheat and Bake to maintain
a precise temperature range for optimal cooking results.
The bake and broil elements or burners cycle on and off
in intervals. On convection range models, the fan will run
while preheating and may be cycled on and off for short
intervals during Bake to provide the best results. This feature
is automatically activated when the oven is in use.
Before baking and roasting, position racks according to the
"Positioning Racks and Bakeware" section. When roasting, it is
not necessary to wait for the oven preheat cycle to end before
putting food in, unless it is recommended in the recipe.

Broiling

NOTE: The convection fan will shut off when the oven door
is opened. If the oven door remains open for too long, the
heating elements will shut off until the oven door is closed.
All timers, including any active Cook Time or Timed Cook
functions, will continue to count down.
IMPORTANT: Close the door to ensure proper broiling
temperature.
Changing the temperature when custom broiling allows more
precise control when cooking. The lower the broil setting is, the
slower the cooking. Thicker cuts and unevenly shaped pieces of
meat, fish, and poultry may cook better at lower broil settings.
Use rack position 6 or 7 for broiling. Refer to the "Positioning
Racks and Bakeware" section for more information.
On lower settings, the broil element will cycle on and off to
maintain the proper temperature.
For best results, use a broiler pan and grid. It is designed
■
to drain juices and help avoid spatter and smoke.
To purchase a broiler pan, Part Number 4396923 may be
ordered from sears.com. See the back cover of this Use
and Care Guide for additional contact information.
NOTE: Odors and smoke are normal the first few times the
oven is used or if the oven is heavily soiled.