Controller Module Leds - Bosch DVA-08K Installation Manual

RAID Subsystem DVA-08K | Installation Manual
LED Name
Drive Busy
Power Status
Table 4.2 Drive Tray LED Definitions
4.2.3

Controller Module LEDs

The rear-facing faceplate of the RAID controller module is shown in Figure 4.2. The rear-facing
faceplates on the two models look identical. The LEDs are numbered from 1 to 5. There are
two more LEDs on the Ethernet port. The definitions are shown in Table 4.3 below.
Fig. 4.2 Controller Faceplate
LED
1
2
3
4
5
Table 4.3 Controller Module LED Definitions
Bosch Security Systems
Color
Blue ON indicates read/write activity on the drive.
OFF indicates there is no read/write activity on the drive.
Red/ GREEN indicates that power is being supplied to the drive.
Green OFF indicates no power is being supplied to the drive or the
drive tray is not properly installed. .
RED indicates drive failure or faults have occurred.
Name
Controller Ready Green
Hst_Bsy Green
(Host Ports Busy)
Drv_Bsy Green
(Drive Busy)
C_Dirty Amber
(Cache Dirty)
BBU_Fail Amber
Status
Color
ON: Indicates controller is active and
operating normally.
FLASHING: Indicates controller initial-
ization is taking place.
OFF: Controller is not ready for opera-
tion.
FLASHING: Activities on the host ports.
OFF: No activities on the host ports.
FLASHING: Activities on the drive side.
OFF: No activities on the drive side.
ON: Indicates that data is currently
being cached in memory or is being
held up by the BBU during a system
power loss.
ON: Indicates the BBU has failed and
cannot sustain cached data.
OFF: Indicates the BBU can sustain
cached data in memory.
FLASHING: The BBU is charging.
Subsystem Monitoring | en
Status
F.01U.027.797 | V1 | 2006.05
25