Runco Video Xtreme VX-44d Owner's Operating Manual page 66

Installation
• Pre-Calibration: Keep off for virtually all sources (default). Temporarily enter a check
mark only if you are an experienced technician and you have an unusual source that
you feel needs further color temperature and/or white balance adjustment. After
entering a check mark, wait for the six slidebar values to stabilize, then clear the check
mark and exit. This compensates for incoming out-of-range drives (white) and black
levels (black) that would cause "crushing" of light and dark colors in the image.
1. There must be at least two consecutive white pixels present in
Note
2. Uncheck this item before exiting this menu.
• Black Levels and White Levels: To check your image and adjust these controls:
1. Make sure overall "Contrast" and "Brightness" settings are both set to near 50. (Not
required for "Pre-Calibration" adjustment.)
2. Check the color temperature setup using an internal grayscale test pattern, making
sure to obtain a neutral grayscale. (Not required for "Pre-Calibration" adjustment.)
3. If the blacks and/or whites appear OK, input levels do not need adjustment. If black
levels are too high (and/or whites are too low, which is rare), you likely have a noisy
source that is producing skewed input levels. Continue with Step 4.
4. Temporarily enable "Pre-Calibration" in the White Balance submenu. Wait for all six
values to stabilize. Alternatively, do not use "Auto" — reduce black levels manually
instead. Judge by eye and change one or more of the six levels as necessary to
obtain proper blacks and whites. You may want to see only a certain color while
adjusting; if so, use the "Color Enable" option (described below).
5. Delete the "Auto" check mark and exit the White Balance menu.
• Auto Color Enable: When a check mark is present, selecting a specific black level or
drive to adjust will automatically enable the corresponding color in the display. Delete
the check mark to see all colors.
• Clamping: This option can brighten the image produced from certain high-resolution,
high-frequency graphic sources. For almost all sources, the best clamp location is
automatically selected by the projector.
• Use the normal Back Porch location if the image is either sufficiently bright or overly
bright.
• Select Sync Tip if the image appears unusually dim, if there are horizontal streaks
across the image, or if there is significant color drift. This moves the clamping pulse
from the normal back porch location (which is likely too short) to the tip of the
horizontal sync pulse.
• Tri Level is typically recommended for an HDTV source where the back porch is
also short, or for video sources or any RGB source with sync information included
on the video (for example, sync-on-green).
the image for the "Pre-Calibration" function to work properly.
Otherwise, input levels may produce skewed colors, particularly
in non-video images.
54 Runco VX-44d/-55d Owner's Operating Manual