Table of Contents
Advertisement
IDENTIFICATION OF CONTROLS
REAR PANEL
10 ETHERNET/LOCAL AREA NETWORK (LAN) PORT
•
LAN connection must be setup for wired connection to be
established. Set up a Wired Ethernet broadband router with
broadband internet connection. Your router or home network
should have a built-in DHCP server to consummate the connection.
•
Using a standard straight-through Ethernet cable (not supplied),
connect one end of the Ethernet cable to the LAN port of your
wired Ethernet broadband router and the other end to M17's LAN
port.
•
This Ethernet connection has similar function as that of the RS232
connection. With your PC and the M17 on the same network,
it allows remote control of the M17 via compatible external
controllers.
•
The IP address of your network-connected M17 can be obtained.
Press and hold "Main" item in the front panel display menu until
below information is displayed.
NOTES
•
NAD is not responsible for any malfunction of the M17 and/or the
internet connection due to communication errors or malfunctions
associated with your broadband internet connection or other
connected equipment. Contact your Internet Service Provider (ISP) for
assistance or the service bureau of your other equipment.
•
Contact your ISP for policies, charges, content restrictions, service
limitations, bandwidth, repair and other related issues pertinent to
internet connectivity.
USB
•
Connect the USB connector of the supplied BluOS/USB hub to this
USB input. Ensure that the Wi-Fi dongle and Bluetooth USB Micro
Adaptor are securely connected to any of the 4 ports of the USB
hub. If wireless connectivity is poor, connect Wi-Fi dongle to the
supplied extension cable and straighten out for better reception.
•
Refer to the instructions on HOW TO SETUP WIRELESS CONNECTION
in the BluOS SETUP menu below.
11 POWER
•
AC mains power is supplied to M17.
•
When the POWER switch is set to ON position, the M17 goes to
standby mode as shown by the amber status condition of the front
panel Power indicator. Press the front panel o (Standby) button or
HTRM 2 remote control's [ON] button to switch ON the M17 from
standby mode.
•
If you intend not to use the M17 for long periods of time (such as
when on vacation), switch off the POWER switch.
•
With POWER switched off, neither the front panel o (Standby)
button nor HTRM 2 remote control's [ON] button can activate the
M17.
10
12 AC MAINS INPUT
•
The M17 comes supplied with a separate detachable mains power
cord. Before connecting the plug to the mains power source,
ensure that it is firmly connected to the M17's AC Mains input
socket first.
•
Always disconnect the mains power plug from the mains power
source first, before disconnecting the cable from the M17's AC
Mains input socket.
•
Connect only to the prescribed AC outlet, i.e., 120V 60 Hz (for 120V
version models only) or 230V 50 Hz (for 230V version models only).
Advertisement
Table of Contents
