Advertisement
After unpacking your ShowerSpa, some assembly is required prior to installation.
Shelf Assembly
1. Place ShowerSpa (1) onto top of shelf (4) and insert shelf studs (11) through holes.
2. Place metal washers (10) on screws (11) and secure shelf mounting nuts to underside of shelf. Use a wrench
to tighten.
Diverter Hose Assembly
1. Attach jet hose (15) to jet outlet (7) located on diverter (13). Make sure jet hose (15) is attached to outlet
located on right side when facing the back of the ShowerSpa (1). Tighten with wrench.
2. Attach rain shower hose (18) to rain shower outlet which is the highest oulet located in the center of the
diverter (13) when facing the back of the unit. Tighten with wrench.
3. Attach supply hose (16) to supply inlet (19) located on diverter (13). Make sure supply hose (16) is
attached to outlet which is located closest to back of ShowerSpa (1). Tighten with wrench.
PLEASE REFER TO FIGURE A (REAR VIEW OF DIVERTER) FOR DETAILED DRAWING
Hand Shower Assembly
1. Insert washer (12) into hexagon-shaped end of hand shower hose (5) and attach to threaded outlet on
bottom of ShowerSpa (1). Do not over-tighten.
2. Insert washer (12) into tapered end of hand shower hose (5) and attach to hand shower (2). Insert hand
shower into holder (3).
Assembly
5
Advertisement
