Remove The Discharge Grille; Remove The Control Board - Panasonic CS-MZ20UFEA Service Manual

18.3 Remove the Discharge Grille.

6. Release the 2 screws to take
out of the Discharge Grille.
5. Release the screw to
remove the nanoeX
Generator complete.

18.4 Remove the Control Board

1. Detach the Indicator complete from
Discharge Grille
nanoeX Generator
Complete
4. Release the Terminal and
connectors as below from
the main PCB;
1) CN-TH
2) CN-STM2
3) CN-STM1
4) CN-NANO
5) AC303
6) CN-FM
the Discharge Grille and release the
connector CN-DISP.
Main PCB
1. Take out the Control board cover.
101
2. Detach the Receiver complete
from the Discharge Grille and
release the connector CN-RCV.
3. Remove the Control Board cover.
" " Caution!
Do not pull out these
connectors lead wire
(CN-DISP & CN-RCV)
due to it fix at the main PCB.