Removal steps of the hall sensor cable
Note: Do not close the connector flips before connecting the cable. When connecting the cable, ensure that
the connector is attached firmly.
1070 Volume control board and cable
Before you replace the volume control board and cable, do the following:
1. Disable the built-in battery. See "Disabling the built-in battery" on page 54.
2. Remove the Nano-SIM-card and microSD card tray, nano-SIM-card, and microSD card. See "Removing
the Nano-SIM-card and microSD card tray, nano-SIM-card, and microSD card" on page 54.
3. Remove the following FRUs:
• "1010 Back cover assembly and LCD module" on page 55
• "1020 Speaker assembly" on page 61
• "1030 Built-in battery" on page 63
Removal steps of the volume control board and cable
Note: Do not close the connector flips before connecting the cable. When connecting the cable, ensure that
the connector is attached firmly.
.
Chapter 7
Removing or replacing a FRU
67