Daewoo DTU-14XX ME Service Manual page 11

ALIGNMENT INSTRUCTIONS
4.5.2 OPTION 2 BITS
Remote control(Bit 7)
This is not intended to be changed by use of the FACTORY remote control.
NEC/Da ewoo Remocon (Bit 6)
User remote control configuration, the choice being between the following;
§ NEC remocon ( 1)
§ Daewoo R-46G22 ( 0)
The R-30SVC7 FACTORY remote control will never be affected by this setting.
AV out option (Bit 5)
This allow you to select the desired signal at output pin 46. When set to 1 the output is monitor
out otherwise the output is the CVBS signal demodulated from the tuner IF. Sound output is also
switched (#37 and #38).
Local keyboard option (Bit 3 & 2)
0 mV ~ 220 mV
220 mV ~ 620 mV
620 mV ~ 1.06 V
1.06 V ~ 1.48 V
1.48 V ~ 1.79 V
1.79 V ~ 2.07 V
Digital eye ON/OFF (Bit 1)
Enables/disables the digital eye function.
When enabled and selected, the microcontroller measures DC level on IC pin15, and adjusts
picture setting according to the table below.
0 mV ~ 450 mV
450 mV ~ 900 mV
900 mV ~ 1.35 V
1.35 V ~ 1.80 V
1.80 V ~ 2.25 V
2.25 V ~ 2.70 V
PARS Logo ON/OFF (Bit 0)
Enables/disables the display of PARS logo at power on.
4.5.3 OPTION 3 BITS
Curtain function at power ON(Bit 7)
Enables/disables the curtain function at power ON. The frequency and volume of associated
beep sound is controlled by NVM data.
11
Not used
(TV/AV) Menu
Vol. Up
Vol. Dwn
Prog. Up
Prog. Dwn
Brightness Contrast
18
28
30
32
34
36
10
Menu
TV / AV Prog. Up
Vol. Dwn Prog. Dwn
Vol. Up Vol. Up
Prog. Dwn Vol. Dwn
Prog. Up TV / AV
Colour
30
46
50
55
60
63
-10-
01
Menu
Not used
Sharp ness
26 27
28 29
29 30
30 31
31 32
32 33
00
4