Advertisement
Quick Links
FLECK XTR2 FIELD PROGRAMMER
INSTALLATION AND OPERATION INSTRUCTIONS
The XTR2 Field Programmer allows you to connect a PC to the
XTR2 control via USB for field programming and diagnostic
data download. The Field Programmer application features a
simple graphical interface for easy control programming.
SOFTWARE INSTALLATION
The following hardware and software is required to install the
XTR2 Field Programmer application:
• Licensed copy of XTR2 Field Programmer installation file
Minimum system requirements
Operating
Windows 7, Windows 8, Windows 8.1, Windows 10
system
CPU
Memory
Hard drive
Do not connect XTR2 before installing the field
CAUTION
programmer.
To install the XTR2 Field Programmer application:
1. Locate the FPA_Installer.exe file included with your Field
Programmer installation package. Double-click on the file
to begin installation.
2. The InstallShield Wizard will appear, and will walk you
through the rest of the installation process. Click Next
to continue, and follow the prompts to complete the
installation.
Figure 1 Field Programmer InstallShield Wizard
3. When installation is complete, the Pentair Field
Programmer shortcut will appear on your desktop and in
your Start menu.
1 GHz
512 GB RAM
2 GB of free space
4. Launch the Field Programmer application by double-
clicking the desktop icon or selecting the Start menu item.
The Field Programmer Master Programming Settings
window appears.
Settings Menu
Figure 2 Field Programmer Master Programming Settings
FIELD PROGRAMMER FEATURES
The Field Programmer application features an easy to use
graphical interface designed to complement the look and feel
of the XTR2 control.
The main screen used when programming is the Master
Programming Setting screen (see Figure 2). This screen can
be divided into three main interface areas: the Master Settings
Menu, Data Transfer Icons, and the Programming area.
Master Settings Menu
The Master Settings Menu organizes master settings
parameters into several categories, listed below. Click the
menu item to display the parameter set.
Improperly adjusting master settings may cause
CAUTION
the system to operate incorrectly.
NOTE: Please refer to the Fleck 5800 or 5810/5812 XTR2 Service
Manuals for complete master settings procedures and
parameter descriptions.
• format: Contains initial control setup and format
settings.
• valve: Contains settings specific to the valve and system.
• regen: Contains settings specific to the selected
regenerant flow.
• relay: Contains auxiliary relay settings.
• diagnostic: Displays diagnostic information that can be
downloaded from the control.
• summary: Displays a summary of all programmed
settings.
Control
Successfully
Connected
Master Settings
Data Transfer Icons
waterpurification.pentair.com
Advertisement
Summary of Contents for Pentair FLECK XTR2
-
Page 1: Software Installation
• regen: Contains settings specific to the selected Figure 1 Field Programmer InstallShield Wizard regenerant flow. 3. When installation is complete, the Pentair Field • relay: Contains auxiliary relay settings. Programmer shortcut will appear on your desktop and in • diagnostic: Displays diagnostic information that can be your Start menu. - Page 2 FIELD PROGRAMMER FEATURES continued editing. Settings change from blue to light gray when selected. Settings that are displayed in dark gray are not editable based Data Transfer Icons on current programming settings. Click anywhere in the Field Programmer Master Programming Settings window to de- The data transfer icons at the bottom of the Field Programmer select a selected setting.
- Page 3 8. If you have not already done so, launch the Field Programmer software on your PC by double-clicking on the Pentair Field Programmer icon or selecting the menu item from the Start menu. The Field Programmer Master Programming Settings window appears (see Figure 2).
- Page 4 For a detailed list of where Pentair trademarks are registered, please visit waterpurification.pentair.com/brands. § Pentair trademarks and logos are owned by Pentair plc or its affiliates. Third party registered and unregistered trademarks and logos are the property of their respective owners.