Goodman GMEC96 Service Instructions Manual page 8

PRODUCT IDENTIFICATION
MODEL # MFG #
AFE18-60A
AMU1620
P1251305F
AMU1625
P1251306F
AMU2020
P1251307F
AMU2025
P1251308F
GMU1620
GMU1625
GMU2020
GMU2025
ASAS-10 P1251301F
ASAS-11 P1251302F
ASAS-12 P1251303F
ASAS-18 P1251304F
P1254001F
DCVK-20 (CVENT - 2)
P1254002F
DCVK-30 (CVENT - 3)
0170K00000S
0170K00001S
P1221001
EFR02
P1221002F
LPLP03
RF000142
CFSB17
CFSB21
CFSB24
8
Fossil Fuel Kit. The AFE18-60A control is designed for use where the indoor coil is located
N/A above/downstream of a gas or fossil fuel furnace when used with a heat pump. It will
operate with single and two stage heat pumps and single and two stage furnaces
Media Air Cleaner. The Amana (AMU*) and Goodman (GMU*) Media Air Cleaner is a high
efficiency air filtration device designed to remove dirt, dust, pollen and other microscopic
particles from the air passing through it. Flexible performance range up to 2,0
N/A
Electronic Air Cleaner. The High-Efficiency Electronic Air Cleaner is designed to remove air
contaminants down to .01 microns. Carbon filters (optional) remove odors. Dual indicator
lights show unit operation at a glance. Electronic proving switch cycle
Concentric Vent Kit. For use with Amana® Brand high efficiency furnace models. This kit is
designed to allow terminations of a direct vent furnace to be "concentrically" vented through
a wall or roof. This kit allows a single penetration to support termin
Side Wall Only Concentric Vent Kit. For use with high efficiency furnace models. This kit is
N/A to be used with 2" - 3" vent systems. The vent kit must terminate outside the structure. This
kit is NOT intended for use with single pipe (indirect vent) instal
Side Wall Only Concentric Vent Kit. For use with high efficiency 90% furnace models. This
N/A kit is to be used with 2" only vent systems. The vent kit must terminate outside the structure.
This kit is NOT intended for use with single pipe (indirect vent) in
External Filter Rack Kit. This kit is intended to provide a location, external to the furnace
casing, for installation of a permanent filter. The rack is mounted over the indoor air blower
compartment area of either side panel, and provide filter retentio
LP Gas Low Pressure Kit. Designed for application on Goodman® and Amana® Brand's
N/A 80% and 90% single-stage and two-stage gas fired furnace products installed on LP gas
listed in this manual. This kit includes harness adaptors to work with White-Rodgers sin
Vent Drain Coupling. For use when the furnaces is installed in horizontal left position and
N/A the internal elbow is removed. May also be used in the combustion air intake if
condensation is an issue.
Counterflow Subbase Kit. For use with Amana® Brand, Goodman ® brand 96% two stage
34.5 furnace model. These kits are available for the following furnace width: 17.5" wide
(CFSB17), 21" wide (CFSB21, and 24" Wide CFSB21. The kit must be used to prevent
N/A excessive temperature from reaching combustible materials, if the furnace is installed on
combustible floor. This subbase effectively separated the furnace base and plenum from
combustile materials. To ensure safe installation, do not install the counterflow floor base
directly on carpeting, tile or other combusible material other than wood flooring.
DESCRIPTION