Usb Device Connection - Sony HT-S200F Operating Instructions Manual

subwoofer may be difficult to hear.
Play the built-in demonstration music
by following the steps below and
check that the sound is output from
the subwoofer.
 Press and hold
Speaker for 5 seconds.
The built-in demonstration music
is played.
 Press
again.
The built-in demonstration music
is canceled and the system
returns to the previous status.
 Set the night mode to off. For details,
see "Enjoying Clear Sound with Low
Volume at Midnight (NIGHT)"
(page 22).
 The subwoofer is on the bottom of
the Bar Speaker. Make sure not to hit
obstacles on the subwoofer.

USB Device Connection

The USB device is not recognized.
 Try the following:
 Turn the system off.
 Remove and reconnect the USB
device.
 Turn the system on.
 Make sure that the USB device is
securely connected to the
port (page 20).
 Check to see if the USB device or a
cable is damaged.
 Make sure that the USB device is on.
 If the USB device is connected via a
USB hub, disconnect it and connect
the USB device directly to the system.
Mobile Device Connection
BLUETOOTH connection cannot be
completed.
 Make sure that the BLUETOOTH
indicator on the Bar Speaker is lit
(page 8).
32
US
 Make sure the BLUETOOTH device to
 Bring the BLUETOOTH device close to
 Pair this system and the BLUETOOTH
on the Bar
 If the BLUETOOTH function is set to
Pairing cannot be achieved.
 Bring the BLUETOOTH device close to
 Make sure this system is not receiving
 Pairing may not be possible if other
Sound of the connected
BLUETOOTH mobile device is not
output from the system.
 Make sure that the BLUETOOTH
(USB)
 Bring the BLUETOOTH device close to
 If a device that generates
 Move the USB 3.0 device and its cable
 Remove any obstacle between this
be connected is turned on and the
BLUETOOTH function is enabled.
the system.
device again. You may need to cancel
the pairing with this system using
your BLUETOOTH device first.
off, set it to on (page 26).
the system.
interference from a wireless LAN
device, other 2.4 GHz wireless
devices, or a microwave oven. If a
device that generates
electromagnetic radiation is nearby,
move the device away from this
system.
BLUETOOTH devices are present
around the system. In this case, turn
off the other BLUETOOTH devices.
indicator on the Bar Speaker is lit
(page 8).
the system.
electromagnetic radiation, such as a
wireless LAN device, other
BLUETOOTH devices, or a microwave
oven is nearby, move the device away
from this system.
away from this system.
system and the BLUETOOTH device or
move this system away from the
obstacle.