Advertisement
5
Setting the switch password
Your switch ships with the default password: password. Change the password of your switch and keep the new
password in a secure location for reference. Write your password here if needed:
_______________________________________
1. Enter your password in the Set Parameters screen and follow the onscreen prompts.
2. Enter a new name for the switch at this time, if desired. Accept the displayed date and time and click Next.
6
Configuring the zones and performing device
selection
1. Select Typical Zoning on the Zone Configuration screen and click Next.
Typical Zoning is the default zone configuration. See the EZSwitchSetup Administrator's Guide for more
information on zone configuration.
2. Enter the number and types of devices that you are connecting to the switch on the Device Selection
screen.
EZSwitchSetup uses these values to automatically configure the ports on your switch for the devices that you
are connecting.
Connecting devices
7
The Connect Devices screen displays a graphical representation of the switch with the device connections
based on the information that you entered when you configured zones and performed device selection. The
Connect Devices screen will show all physical connections as missing until you connect the devices that you
specified.
1. Install the SFP transceivers in the Fibre Channel ports on the switch to match the ports shown onscreen.
!
1a
a. Remove any protector plugs from the SFP transceivers
you are going to use, and position and insert each SFP
transceiver as required (right side up in the top row of
ports and upside down in the bottom row of ports).
Push the SFP until it is firmly seated.
b. Close the latching bale. Repeat for the other ports.
2. Connect Fibre Channel cables from the switch (shown below) to your host and storage devices (not shown).
Make the physical connections to match the connections on the Device Connection screen.
!
3. The Finish screen will display this message: "Congratulations—you've successfully completed the setup!"
4. Click Finish to exit setup.
You are now ready to configure the storage component of the SAN using the documentation that came
with the storage server(s).
© Copyright International Business Machines Corporation 2017. All rights reserved. US Government Users Restricted Rights – Use,
duplication or disclosure restricted by GSA ADP Schedule Contract with IBM Corp.
© 2017 Brocade Communications Systems, Inc. All Rights Reserved.
GI13-4578-00
IBM, the IBM logo, and ibm.com are trademarks or registered trademarks of International Business Machines Corporation in the
United States, other countries, or both. A complete and current list of other IBM trademarks is available on the Web at
www.ibm.com/legal/copytrade.shtml
a. Remove plastic protector caps from the Fibre Channel cable
ends (if there are any), and position the cable connector so
that it is oriented correctly.
b. Insert the cable connector into the SFP until it is firmly seated
and the latching mechanism clicks.
c. The Device Connection screen shows missing, valid, and
invalid connections as you cable the switch. Note that it can
take up to 15 seconds for the connection to display as a valid
connection. Verify that the connections are all green and click
Next.
01JC078
Advertisement
