Panel Description; Left Channel; Right Channel; Phones Jack - Roland Dm-10 Owner's Manual

Panel Description

Left Channel

fig.2
1. L Channel Input Jack
Connect this to L Channel Output Jack 14 on the right-
side unit. For the connection, use the included speaker
cable.
2. POWER Switch, POWER/STANDBY Indicator
The POWER/STANDBY Indicator lights up in red
during standby, and lights up in green when power is on.

3. PHONES Jack

When you connect headphones to this jack, no sound
will be heard from the speakers.
4. BASS Control Knob
5. TREBLE Control Knob
These adjust the tones of the bass and treble. Set to center
to make the tones flat.
6. VOLUME Knob (DIGITAL/LINE 1)
This adjusts the volume of devices connected to digital
input connectors 8, 9, 11, and LINE 1 Input Jack 12.
7. VOLUME Knob (LINE 2)
This adjusts the volume of the device connected to LINE
2 Input Jacks 13.
8. Digital Input Connector (Optical)
This is the digital input connector for optic-fiber cable.
* When you connect a cable to this connector, the sound of
devices connected to digital input connector 9 or 11 will
not be heard.
6

Right Channel

fig.3
FROM RIGHT
1
9. Digital Input Connector (Optical)
10. Digital Input Select Switch
11. Digital Input Connector (Coaxial)
12. LINE 1 Input Jack (stereo mini type)
13. LINE 2 Input Jacks (L, R) (RCA pin type)
14. L Channel Output Jack
15. AC Inlet
2 3 4 5 6 7 8
This is the digital input connector for optic-fiber cable.
This switch selects digital input connector 9 or 11 on the
rear panel. Select the connector used for the input signal.
* When you connect a cable to digital input connector 8 on
the front panel, the sound of the device connected to 8
will be heard independently of this switch.
This is the digital input connector for coaxial cable.
Connect this to L Channel Input Jack 1 on the left-side
unit.
Connect the included Power cord here (p. 17). Plug it
firmly in, so that the cable does not accidentally become
disconnected.
9 1011
12 13 14 15