Table of Contents
Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
30" ELECTRIC SLIDE-IN RANGE
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
United States
Table of Contents
Important Safety Instructions .......................................... 2
Product & Cabinet Dimensions.................................... 3-4
To Avoid Breakage .......................................................... 5
Serial Plate Location....................................................... 6
Factory Connected Power Supply Cord ......................... 6
Power Supply Cord Kit ................................................... 6
Access to Terminal Block & Grounding Strap ................. 6
Important Notes to the Installer
1. Read all instructions contained in these installation
instructions before installing range.
2. Remove all packing material from the oven and
the drawer compartments before connecting the
electrical supply to the range.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the
consumer.
Printed in United States
FOR YOUR SAFETY: Do not store or
use gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
INSTALLER.
Electrical Connection to the Range ............................. 7-8
Cabinet Construction ................................................... 8-9
Range Installation ...................................................... 9-10
Leveling the range ........................................................ 10
Check Operation............................................................11
Anti-Tip Brackets Installation ................................... 12-13
Important Note to the Consumer
Keep these instructions with your owner's guide for
future reference.
Canada
P/N 318201632 (1602) Rev.B
English - pages 1-13
Spanish - pages 14-26
Français - pages 27-40
Advertisement
Table of Contents
Related Manuals for Frigidaire CGES3065PW
Summary of Contents for Frigidaire CGES3065PW
-
Page 1: Table Of Contents
INSTALLATION INSTRUCTIONS 30" ELECTRIC SLIDE-IN RANGE INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. United States Canada FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. -
Page 2: Important Safety Instructions
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS This manual contains important safety symbols and instructions. Please pay attention to these symbols and follow all instructions given. This symbol will help alert you to situations that may cause serious bodily harm, death or property damage. -
Page 3: Product & Cabinet Dimensions
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS Product Dimensions Do not install the unit in the cabinet before reading next two pages. Side Panel A. HEIGHT C. COOKTOP D. TOTAL DEPTH TO FRONT B. WIDTH (Under Cooktop) WIDTH OF RANGE 35 3/4" (90,8 cm) 30"... - Page 4 30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS 30" Min. Cabinet Dimensions (76,2 cm) Min. 13" (33 cm) 30" Min. (See page 3, Countertop hatched note 3) surfaces should be flat (76,2 cm) Min. (See & leveled. page 3, note 3) 18" Min. ½"...
-
Page 5: To Avoid Breakage
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS To avoid breakage: Do NOT handle or manipulate the unit by the cooktop. 1. The counter-top around the cut-out should be flat and leveled (see hatched area on illustration 1) 2. Before installing the unit, Shave measure the heights of 1 ½" Max. Raised (3.8 cm Max.) the two (2) cabinet sides Edge to... -
Page 6: Serial Plate Location
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS Serial Plate Location You will find the model and serial Electrical Shock Hazard number printed on the serial plate. • Electrical ground is required on this appliance. The serial plate is located as • Do not connect to the electrical supply until shown. -
Page 7: Electrical Connection To The Range
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS DO NOT loosen the screws that attach the terminal Electrical Connection to the block to the appliance. Range (U.S.A.) 3. Using the nuts supplied with the literature package, Three Conductor Wire Connection to connect the ground wire (green) of the copper power supply cord to the frame of the appliance with Range the ground screw, using the hole in the frame where... -
Page 8: Cabinet Construction
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS 1. Be sure that no power is supplied on the cable from Cabinet Construction residence. 2. DO NOT remove the grounding strap for 3-wire To eliminate the risk of burns installation. or fire by reaching over heated surface units, do not 3. In the circuit breaker, fuse box or junction box: have cabinet storage space above the range. - Page 9 30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS 1. Draw a center line (CL) on the floor where the range Anti-Tip Brackets Installation should be installed. Also draw a line on the floor at the range back position if there is no wall. Models Equipped with Leveling Device 2. Unfold paper template and place it flat on the floor with the right rear corner positioned exactly on the To reduce the risk of tipping of the intersection of the center and back lines you just range, the range must be secured to the floor by drew before.
- Page 10 30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS C. Level and position the range - Slide range to its Models Equipped with Leveling Legs final position. Insert the range leveling leg in the anti-tip bracket. Visually verify if the anti-tip bracket is engaged. To reduce the risk of tipping of the Lower the range by adjusting the 4 leveling legs range, the range must be secured to the floor by the alternatively until the range is level.
-
Page 11: Range Installation
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS Range- Models Equipped with Leveling Device". Range On models with a leveling device, remove the 8.13 Installation rear legs and discard. Adjust the leveling legs Important Note: on the front of the appliance so that the cooktop Door removal is not glass clears the countertop. -
Page 12: Leveling The Range
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS Leveling the range Models Equipped with Leveling Legs Models Equipped with Leveling Device Level the range and set cooktop height before Level the range after installation in the cutout installation in the cut-out opening. opening. -
Page 13: Check Operation
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS Decorative Rear Trim 11.2 Operation of Oven Elements Installation (some models) The oven is equipped with an electronic oven control. Each of the functions has been factory checked before 1. Disconnect the power from the range. shipping.