Change The Programme; Forgot To Add A Dish; At The End Of The Wash Cycle - Candy CDP 2L1049W-80 Instruction Manual

10 place settings
Table of Contents

Advertisement

NOTE:
[ P1 - Intensive, P2 - Normal, P3 - Eco, P4 - Rapid, P5 - Soak ]

Change the Programme

Premise:
1
A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
2
Press the Start/Reset button for more than 3s, the machine will be instand by state. then you can change the
program to the desired cycle setting (see the section entitled " Starting a wash cycle. . ." ).
NOTE:
NOTE:
If you open the door during a wash cycle , the machine will pause. The program light will
stop blinking and the buzzer will moo every minute untill you close the door . After
you close the door ,the machine will keep on working after 10 seconds.
If your model has broken remember function, the machine will go on to finish the selected
program after the power cut.

Forgot to Add a Dish?

A forgotten dish can be added any time before the detergent cup opens.
1
Open the door a little.
2
After the spray arms stop working, you can open the door
completely.
3
Add forgotten dishes.

At the End of the Wash Cycle

When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
The program light is on but is not blinking, only in this case the programme has ended.
1.Switch off the dishwasher by pressing the On/Off Button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
WARNING!
It is dangerous to open the door when washing,
because the hot water may scald you.
4
Close the door.
5
The dishwasher will run after 10 seconds.
12
12

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents