Making The Connections; Control Panel; Jack Panel - Roland CM-30 Owner's Manual

Making the Connections

Refer to the figure shown below to connect the CM-30 and the other equipment.
Recorder
OUTPUT
Stereo Link (p. 10)
Here is an example of a setup that makes full use
of the CM-30's mixer and monitor functions.
A mic is input to CH 1, which accepts mic level
input. Connect a keyboard, recorder, or other
sound-generating devices to the CH 2 and CH 3
inputs.
* To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn off
the power on all devices before making any connections.
Set all of the CM-30's channel volume knobs as well as
the MASTER knob to zero.
8
Keyboard
OUTPUT
MD Player

Control Panel

Mic

Jack Panel

* Howling could be produced depending on the location of
microphones relative to speakers. This can be remedied
by:
1. Changing the orientation of the microphone.
2. Relocating microphone at a greater distance from
speakers.
3. Lowering volume levels.
* When connection cables with resistors are used, the
volume level of equipment connected to the inputs (CH 1
through CH 3, AUX IN 1 and 2) may be low.
If this happens, use connection cables that do not contain
resistors, such as those from the Roland PCS series.
Stereo
Headphones
CD Player