HP L6017tm Installation Instructions

Installation Instructions
HP Retail Integrated
7-inch CFD
RP7 7800
L6015tm
RP7 7100
L6017tm
Copyright © 2014 Hewlett-Packard Development Company, L.P. The
information contained herein is subject to change without notice.
Printed in
First Edition: January 2014
*758427-B21*
758427-B21
NOTE: Refer to the HP L6015tm and L6017tm Retail Touch Monitors
User Guide, the HP RP7 Retail System Model 7800 Hardware
Reference Guide, or the HP RP7 Retail System Model 7100 Hardware
Reference Guide at www.hp.com for detailed instructions on
installing USB modules.
Before Your Begin
Before installing the liquid-crystal display (LCD), be sure to power off the
system and disconnect the power cord from the power outlet.
WARNING! To avoid the risk of serious injury or damage to the
system, ensure that the power cord is unplugged from the electrical
outlet at the wall before installing the LCD. Failure to do so may
expose you to the risk of electric shock.
NOTE: For regulatory and safety notices, refer to the Product
Notices included with your product.
Configuring the LCD
To configure the LCD, refer to the HP Point of Sale Configuration Guide
(available in English only). The guide is available on the HP factory image
of the RP7 system's hard drive and at www.hp.com. To access the guide on
the factory image:
•
In Windows XP or Windows Embedded POSReady 2009, select Start
> All Programs > HP Point of Sale Information.
• In Windows 7, Windows Embedded POSReady 7, Windows 8.x, or
Industry 8.1, select Start > HP Point of Sale Information.
Check www.hp.com/support for updated software or documentation that
became available between the time your product was manufactured and
delivered to you.
HP L6015tm and L6017tm Retail Touch Monitors
HP RP7 Retail System Model 7800
NOTE: Inserting the screws is a
required step.
NOTE: Inserting the screws is a
required step.