Siemens APOGEE USR5686 Installation Instructions

®
APOGEE Dial-Up Modem

Product Description

Accompanying U.S. Robotics Sportster 56K bps
modem has been factory configured for use with
APOGEE Field Panel Dial-Up Application.
APOGEE Auto-dial Application will reset Insight
modem as needed.
Contents of 538-859 Carton
Description
Sportster 56K Modem Model No. USR5686
1
Power Adapter 120 Vac
7 foot Modular Phone Cord
User Documentation Package
Installation Instructions
1. For international installation, locally purchase U.S. Robotics
Sportster 56K bps modem configured for the country where
used and program settings per this instruction.
Prerequisites

Analog telephone line connected through a NEC
800.30 type telephone primary protector.

UL497A telephone transient suppressor
installed. For field panel a 538-600 telephone
transient suppressor is installed. Suppressor
sold separately or included in modem kits, refer
to Installation Instruction 538-674.

UL1449 listed power line protector. Not required
if plugged into a field panel service box outlet or
outlet assembly.
Expected Installation Time
15 minutes
Warning/Caution Notations
WARNING
CAUTION
Item Number 538-863, Rev. GA
®
Qty.
1
1
1
1
1
Personal injury/loss of life
may occur if a procedure is
not performed as specified.
Equipment damage or loss
of data may occur if the
user does not follow
procedure as specified.
Installation Instructions
WARNING:
Connect modem to telephone line through
a UL497A listed Telephone Transient
Surge Suppressor and and NEC 800.30
telephone primary protector.
Required for modem installation in a field
panel used per Smoke Control Application
and Engineering Manual (125-1806).
WARNING:
Connect modem to power through a
UL1449 listed power protector or field
panel service box outlet.
CAUTION:
Modem must be connected to an analog
telephone line. Using a non-analog line
(e.g., PBX, digital, multi-line) will damage
modem. A transient surge protector is
required.
CAUTION:
This modem has been factory set to
automatically start in the dial-up mode.
Refer to APOGEE Automation Start-Up
Procedures Manual on InfoLink.
External Switch Settings
DIP switches, located on the back of the modem,
have been configured to start-up in the APOGEE
Dial-Up Application for field panels as shown in the
following illustration:
Figure 1 Sportster Modem DIP Switches, Dial-Up
APOGEE Insight Auto-Dial Application will override
DIP switch settings as needed.
Document No. 538-863
October 10, 2011
Page 1 of 2