Table of Contents
Advertisement
Before Fitting
These fitted cooking units are intended for placement in the cutout of a table top
(Illustration 3).
The unit must be connected by an authorized electrician, since this ensures that both
the statutory regulations and the connection conditions of the local electricity supply
company are observed.
Make cutout of 560 mm x 490 mm in the work top with a margin of 55 mm both in front
and behind.
The cooking-unit cupboard must have a protective floor that is at least 30 mm from the
underside of the unit and can only be removed with the use of tools.
Extractor hoods above the unit must be fitted in accordance with the extractor-hood
fitting instructions.
Unit furniture must be treated with a plastic coating or veneer with heat-resistant
adhesive (100 C), as it can otherwise deform or loosen, especially at thinner points.
Fitting
The use of massive wooden wall-side skirting boards on the table top behind the
fitted unit is permissible provided the minimum clearances have been observed.
Alterations of surface colour can be traced to influence of light.
The fitted cooking unit must be installed such that the control switches are positioned
to the right (Illustration 1).
Connection
In cases of electrical connection of the unit, plans must be made for the use of a
facility that enables contact separation from the mains supply of at least 3 mm
for all pins.
Suitable separators are LS switches, fuses and protective devices.
The mains connection cable must be of type H05VV-F or H05VVH2-F at least.
Mains
230...240 V~
400 V 2 N~
Cable
3 x 4²
4 x 2.5²
Supply Voltage
230...240 V
230 V
1 9
Advertisement
Table of Contents
