Table of Contents
Advertisement
1. B
EFORE
What is Included
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that
all parts are present, and have been received in good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture
must be returned, it is important that the fixture be returned in the original box and packing.
AC Power
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture's specifications chart. A fixture's listed current rating is its average
current draw under normal conditions. All fixtures must be powered directly off a switched circuit and
cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used solely for a 0% to 100% switch. Before applying power to a fixture, check that the
source voltage matches the fixture's requirement. Check the fixture or device carefully to make sure
that if a voltage selection switch exists that it is set to the correct line voltage you will use.
Warning!
All fixtures must be connected to circuits with a suitable Earth Ground.
Notes!
Input voltage equals output voltage. Line A must be used when only one line is
needed in order for the unit to function properly.
Safety Instructions
·
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that
they also receive this instruction booklet.
·
This product is intended for indoor use only!
·
To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure there are no
flammable materials close to the unit while operating.
·
The unit must be installed in a location with adequate ventilation, at least 20in (50cm) from adjacent
surfaces. Be sure that no ventilation slots are blocked.
·
Always disconnect from power source before servicing or replacing lamp or fuse and be sure to
replace with same lamp source.
·
Secure fixture to fastening device using a safety chain. Never carry the fixture solely by the cables.
Use its carrying handles.
·
Maximum ambient temperature (Ta) is 104° F (40° C). Do not operate fixture at temperatures higher
than this.
·
In the event of a serious operating problem, stop using the unit immediately. Never try to repair the
unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center.
·
Make sure the power cord is never crimped or damaged.
·
Never disconnect the power cord by pulling or tugging on the cord.
Caution!
There are no user-serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event your unit may require service,
please contact CHAUVET at: 954-577-4455.
Pro-D6 User Manual
Y
B
OU
EGIN
Please read these instructions carefully, which include important
information about the installation, usage and maintenance of this
product.
3
Ø
1 x Pro-D6
Ø
1 x Warranty Card
Ø
1 x User Manual
Rev. 5
Advertisement
Table of Contents
