Advertisement
Software upgrade
Preparation to upgrade software
1)
Start the CD Burning software and create a new CD
project (Data Disc) with the following setting:
Label: DVPXXXX
(No need the label name)
File Name:
DVPXXXX_XX.BIN
Power on the set and open the tray, then press
<5><5>
to check the File Name.
Note: It is required capital letter for the File System
name
2)
Burn the data onto a blank CDR
A. Procedure for software upgrade:
1) Power on the set and insert the prepared Upgrade
CDR.
2) The set will starts reading disc & response with the
following display TV screen:
Upgrade File DETECTED
Upgrade?
Press Play TO START.
3) Press <OK> button to confirm, then screen will
display :
Files coping...
UPGRADING...
4) The upgraded disc will automatically out when files
coping complete, then take out the disc.
5) About 1 minute later, the trace will automatically close
when upgrading complete.
2-1
B. Read out the software versions to
confirm upgrading
1)
Power on the set and press <Setup>
button on the remote control.
2)
Press<1><3><7><9>button to check the
software information.
The software version and other information
are display on the TV screen as follows:
Version
XX.XX.XX.XX (Main
version)
SUB-VER
XX.XX.XX.XX (software
version of
software)
8032
XX.XX.XX.XX
Servo
XX.XX.XX.XX (software
RISC
XX.XX.XX.XX
DSP
XX.XX.XX.XX
Region Code
Caution: The set must not be power off during
upgrading, Otherwise the Main board will be
damaged entirely.
application
version of
Servo)
X
Advertisement
