Advertisement
Available languages
Available languages
Quick Links
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
Tools Needed:
•
Phillips Screwdriver
•
Flat Screwdriver
•
Utility Knife
•
Tape Measure
•
4 Wire Nuts
•
Thermostat Wire
Carton Contents:
PART
NUMBER
R11712
Wall Box
R11713
Cover Plate
32331
Wall Bracket
R11710
Sensor Extension Harness
R11711
Wall Plate Harness
37854-0-0117
INSTALLATION INSTRUCTIONS
PVSRT1-1 REMOTE
TEMPERATURE SENSOR KIT
FOR USE ON: PVS(18,35)(N,P)
DESCRIPTION
Empire Comfort Systems Inc. • Belleville, IL
1.
Select a location for Remote Temperature Sensor Kit. For
best performance select a central location in the heated
room away from drafts from doors or windows.
2.
Create a 2 1/4" wide by 3 3/4" tall opening in the wall for the
wall box. See Figure 1.
QTY
1
1
1
1
1
3.
Insert wall box into opening, use a Phillips screwdriver to
tighten holding tabs and secure the box into the wall. See
Figure 2.
Figure 1
Figure 2
Page 1
Advertisement
Summary of Contents for Empire Comfort Systems PVSRT1-1
-
Page 1: Installation Instructions
Wall Plate Harness Figure 1 Insert wall box into opening, use a Phillips screwdriver to tighten holding tabs and secure the box into the wall. See Figure 2. Figure 2 37854-0-0117 Empire Comfort Systems Inc. • Belleville, IL Page 1... - Page 2 MUST remain clear for the temperature sensor to function properly. Caution: If re-finishing the cover plate after installation, DO NOT paint or cover the temperature sensor. 11. Turn power and gas to the wall furnace back on. Figure 4 Page 2 Empire Comfort Systems Inc. • Belleville, IL 37854-0-0117...
- Page 3 DE PIÈCE R11712 Boîte murale R11713 Plaque de finition murale 32331 Support mural R11710 Faisceau de rallonge de la sonde R11711 Faisceau de fils de la plaque murale Figure 1 3. Insérer la boîte murale dans l’ouverture, utiliser un tournevis Phillips pour serrer les pattes de fixation et fixer la boîte dans le mur. Voir Figure 2. Figure 2 37854-0-0117 Empire Comfort Systems Inc. • Belleville, IL Page 1...
- Page 4 Conserver la sonde de température. Attention : S i l’on pare la plaque de finition avant l’installation, NE PAS peindre ni recouvrir la sonde de température. 11. Rétablir l’alimentation électrique et de gaz à l’appareil de chauffage mural. Figure 4 Page 2 Empire Comfort Systems Inc. • Belleville, IL 37854-0-0117...