Cadillac CTS 2018 Owner's Manual page 62

2. Start the vehicle with the initial
key or RKE transmitter. The DIC
should display the other driver
number not shown in step 1.
Saving Memory Positions
Read these instructions completely
before saving memory positions.
To save preferred driving positions
1 and 2:
1. Turn the ignition on or to ACC/
ACCESSORY.
A DIC welcome message may be
displayed indicating number 1 or
2 for memory recalls.
2. Adjust all available memory
features to the desired driving
position.
3. Press and release SET; a beep
will sound.
4. Immediately press and hold the
1 or 2 memory button matching
the above DIC welcome message
until two beeps sound.
If too much time passes between
releasing SET and pressing 1, the
memory position will not be
saved and two beeps will not
sound. Repeat Steps 3 and 4.
1 or 2 corresponds to the driver
number. See "Identifying Driver
Number" in this section.
5. Repeat Steps 1 4 for a second
driver using 1 or 2.
To save the position for
exit features, repeat Steps 1 4 using
. This stores the position for
getting out of the vehicle.
Save preferred memory feature
positions to both 1 and 2 if you are
the only driver.
Manually Recalling Memory
Positions
Press and hold 1, 2, or
the previously stored memory
positions.
To stop manual recall movement,
release 1, 2, or . Recall can also be
stopped by pressing a power seat, SET,
power mirror, or power steering wheel
SEATS AND RESTRAINTS
control, if memory equipped. The
driver or passenger side mirror must
be selected.
Auto Memory Recall
The vehicle identifies the number of
the current driver's RKE transmitter
(1 8). See Remote Keyless Entry (RKE)
System Operation 0 28. If the RKE
transmitter is 1 or 2, and Auto
Memory Recall is programmed on in
vehicle personalisation, the positions
and easy
saved to the same memory button
number 1 or 2 are automatically
recalled when the ignition is turned
on, or turned from off to ACC/
ACCESSORY. RKE transmitters 3 8
will not provide automatic memory
recalls.
To turn Auto Memory Recall on or off,
see "Vehicle Personalisation Settings"
previously in this section and Vehicle
to recall
Personalisation 0 143.
The transmission must be in P (Park)
to initiate Auto Memory Recall. Auto
Memory Recall will complete if the
vehicle is shifted out of P (Park) prior
to reaching the stored memory
position.
61