How To Operate The Setup Mode - McIntosh MS500 Owner's Manual

Music streamer
Table of Contents

Advertisement

How to Operate the Setup Mode

The McIntosh MS500 is factory configured for imme-
diate enjoyment of superb audio. If you wish to make
changes to the factory default settings, a Setup Feature
is provided to customize the operating settings using a
PC Computer (not supplied) and with the MS500 con-
nected to a HD Monitor/TV. Start the Setup Mode by
performing the following steps:
1. Press the MS500 Front Panel STANDBY/ON
Push-button or press the
(Power) Push-button
on the Remote Control to switch On the MS500.
Refer to page 13 for information on using the
Remote Control. The LED above the STANDBY/
ON Push-button will illuminate. The MS500 will
go through a startup initialization which might
take upwards of 1.5 minutes with it connected to a
HD Monitor/TV indicating the progress. Refer to
figures 1 and 2.
Figure 1
Figure 2
2. When the initialization is completed, the opera-
tional screen will appear and in the upper left cor-
ner is the "Server IP Address: _ _ . _ _. ___. ___.
Write down the IP Address Number, as it will be
used in the next step. Refer to figure 3.
14
IP Address location
Figure 3
Note: If the "Server IP Address" number appears
as 0.0.0.0, the MS500 was unable to obtain an
IP Address from the computer network. Power
down the MS500, wait several minutes and then
Switch it back On. If the MS500 is still unable
to obtain an IP Address, the default automatic
configuration setting (DHCP, Dynamic Host
Configuration Protocol) might have to be set
manually. Contact your Computer Dealer or
the Computer Manufacture for assistance.
3. Using a computer connected to the same network
as the MS500, launch the Internet Web Browser
Application and type in on the "URL-Address
line", the following:
The IP Address Number written down in step 2
HTTP://__.__.___.___/config
Then press Enter on the computer keyboard. Refer to
figure S1. The Setup Tabs at the top of the window:
Setup Option Tabs
Server Settings
Display Settings
Source Settings
Content
Schedule
Firmware
Figure Number
S1
S2
S3
S4
S5
S6
Figure S1

Advertisement

Table of Contents
loading

Table of Contents