Behringer Bass V-AMP Pro Quick Start Manual page 2

Select Patch 1A
Goal: Select patch 1A as the current patch
1. Press the [<] button until numeral 1 is displayed on the front panel
2. Press the [A] button
Roll Your Own Tone
Goal: Pick an amp model, flatten all controls, save your tone, tweak, rock + repeat
1. Spin the AMP knob and select ROCK CLASSIC (Ampeg SVT)
2. Set GAIN to 2 o'clock
3. Set VOLUME, BASS, MID, TREBLE to 12 o'clock
4. Turn off COMPRESSOR + EFFECTS, spin them all the way down
5. Press and hold the [TAP] button to access the secondary parameters *
6. Spin BASS, MID, TREBLE + EFFECTS to 12 o'clock
7. Release the [TAP] button
* Secondary params are DEEP, SHIFT, PRESENCE, ATTACK, 2ND PARAMETER
Turn-off everything that would secretly spoil the quality of the current patch
1. Press [<] + [>] buttons simultaneously to enter EDIT mode
2. Press [A] button (MIDI) and then press [<] until numeral 1 is displayed
3. Press [B] button (DRIVE) and then press [<] until "--" is displayed
4. Press [C] button (CABINETS), turn both BASS + TREBLE knobs to 12 o'clock
5. Press [D] button (X-OVER) and then press [<] until "--" is displayed
6. Press [E] button (DENOISER) and then press [<] until "--" is displayed
7. Exit EDIT mode by pressing the [TUNER] (EXIT) button
Test drive the ROCK CLASSIC amp model
1. Plug in your bass guitar, start playing, set MASTER volume
2. Ride the BASS knob until you're moving some air
3. Tweak GAIN, BASS, MID, TREBLE, + COMPRESSOR knobs until satisfied
4. Save tone to Patch 1A (Press and hold the [A] button for about 3-seconds)
Moving Forward
1. Pick another AMP model
2. Season to taste
3. Save tone to Patch 1B (Press and hold the [B] button for about 3-seconds)
4. Press [A] to return to Patch 1A
You should be all set now from here! :-)