Table of Contents
Advertisement
Specific Safety Information
This section contains important safety information
that is specific to the ST-33Q+. Read these precau-
tions carefully before using the ST-33Q+ to reduce
the risk of electrical shock, fire, or other serious in-
jury.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE!
ST-33Q+ Safety
• Read and understand this operator's manual, and
the instructions for any other equipment in use
and all warnings before operating the ST-33Q+.
Failure to follow all instructions and warnings may re-
sult in property damage and/or serious personal inju-
ry. Keep this manual with the equipment for future use.
• Operating the equipment while in water increas-
es the risk of electrical shock. Do not operate the
ST-33Q+ if the operator or equipment are standing in
water.
• The ST-33Q+ is not designed to provide high volt-
age protection and isolation. Do not use where a
danger of high voltage contact is present.
• Always attach leads before turning the ST-33Q+ on
and always power off the ST-33Q+ before discon-
necting the leads to reduce the risk of electrical
shock.
• Follow local guidelines and call before digging. Lo-
cating equipment uses electromagnetic fields that can
be distorted and interfered with. More than one utility
may be present in a given area. Follow local guide-
lines and service procedures. Confirm location of utili-
ties before digging.
Find Quality Products Online at:
WARNING
GlobalTestSupply
www.
Product Overview
Description
The ST-33Q+ is a powerful, multi-frequency trans-
mitter which can be used in conjunction with a
RIDGID-SeekTech receiver to find buried conductors
such as pipes, cables, and wires. Connect the ST-33Q+
to a RIDGID-SeekTech SR-24 using Bluetooth
motely control the transmitter and view changes from the
receiver. Cut the time it takes to locate facilities by sync-
ing the ST-33Q+ with the SR-24 and removing the need
to walk back and forth between devices.
The ST-33Q+ can apply an active tracing signal to target
a conductor using the following three modes:
Direct Connect — The leads on the ST-33Q+ con-
nect directly to the target conductor and a suitable
ground.
Inductive Clamp — The optional inductive clamp
encircles the target conductor which eliminates
metal-to-metal contact.
Inductive — The ST-33Q+ is placed over an in-line
conductor. The internal antenna will induce a signal
to locate the target conductor.
In addition to a series of default frequencies, the ST-
33Q+ can also accept custom frequency settings up to
490 kHz.
.com
sales@GlobalTestSupply.com
to re-
®
English – 7
Advertisement
Table of Contents
