AcuRite 75322A1 User Manual

BASIC SETUP
1) Battery Installation – remove the battery compartment cover on the back of the
unit and install 2 FRESH "AA" batteries as shown here.
2) Initial Setup – once the batteries are installed, the clock will power up.
The display will appear as follows:
Room Temp indicator
will be flashing
The clock will begin searching for the Atomic signal
If the signal is AVAILABLE– the clock will receive the local time in 3-5 minutes.
The full strength signal indicator bars will appear on the display.
If the signal is NOT readily available – you can manually set the clock and calendar
(SEE MANUAL SETTING INSTRUCTIONS)
After the clock acquires the Atomic clock radio signal (this may take 24-48 hours)
the time, date and daylight saving time changes will update automatically, giving you
maintenance-free operation and perfect time precision.
3) Choose Your Time Zone – You must set your time zone so the clock will display
accurate time once the atomic signal is received:
a. Select your time zone by repeatedly pressing the
see your time zone displayed on the LCD screen.
HAST AKST PST
Hawaii Aleutian Alaska Standard Pacific Standard
Standard Time Time Time
In the event you wish to manually change the clock settings, please use the
instructions on the following page.
Time Zone will
default to PST
(Pacific Standard Time)
Signal Indicator
will be flashing

( )
ARROW until you
MST CST EST
Mountain Standard Central Standard Eastern Standard
Time Time Time
AST
Atlantic Standard
Time