The PA Unit have been discontinued. Therefore, the PA Unit is not possible to order as the repair parts, and
replaced with the PA-2 Unit.
When replacing the PA Unit to PA-2 Unit, you must be modified the MAIN Unit as following.
Delete the Gusket (RA0530900). This part is no longer needed.
Delete the Shield Cover (RA0124501). This part is no longer needed.
Replace the Power Module IC (G1094314 G1095439: RA30H1317M1A-122).
Add the Chip Resistor (J24205102) between Pin 1 and Pin 2 of Q1017 (Power Module IC).
Add the Jumper wire (T51508002) between the Pin 8 of J1001 and Pin 8 of Q1007.
VX-6000 VHF Service Manual
MAIN Unit Modifications
Delete the Gusket
Delete the Shield Cover
Replace the Power Module IC
RA30H1317M1A-122
(P/N: G1095439)
Add the Chip Resistor
1 k-ohm, 1/10 W
(P/N: J24205102)
Add the Jumper Wire
AWG28, 80 mm
(P/N: T51508002)
4-2