The Operation Of Keys; Self-Checking - Pentax G6 User Manual

2.2 The operation of keys

There is a power key in the receiver, the operations are as follows.
Power key
The main function of power key is power on/off and confirm button.
Power on: when the Receiver is in the OFF status (no light), press the power key

for 2 seconds and release it, and then the receiver will enter the initialization
status. Then you will listen beep for three times and the voice broadcast the
current receiver status, it means the receiver powered on successful.
Power off: when the G6 receiver is in the ON status (power supply light ON),

press and hold power key for 3 seconds until all lights blink, then release the
power key and there will be a voice broadcast "power off". Press the power key
to confirm, then G6 will be turned off.

2.3 Self-checking

If the indicators are abnormal or the receiver can't work normally, for example the
Bluetooth can't be connected, the radio mode can't work, it can't connect to the
CORS. Then you can use the automatic detection function, which is Receiver
self-checking. Self-checking will check GPS, radio, GSM, Bluetooth, WIFI and sensor.
During this procession, it has voice guide tell you whether it's normal or not.
1. When the receiver is in powered on status, keep press the power key for 3
seconds until a voice broadcast "if you want to turn off the device", then release
the power key. Keep press the power key again for 3 seconds until you hear a
beep, then there will be voice broadcast "self-check" and you could release the
power key (The new device should be self-checked once).
2. In the process of device self-checking, there will be voice broadcast the test
results. For example, if the wifi self-check is successful, voice broadcast "WIFI
self- check OK" and the led always on until the self-checking is completed. For
example, if the WIFI self-check fails, voice broadcast "wifi self-check error", the
led will continue blink and the buzzer beeps until you restart G6. Self-checking
11