Sequence Instructions List; How To View The Instruction List Table - Mitsubishi Electric A800 Programming Manual

Sequence instructions list

3.23

Sequence instructions list

3.23.1

How to view the instruction list table

Instruction
Classification
symbol
MOV
Transfer
MOVP
 
1) 2)
1): Instructions are classified according to application.
2): Indicates the instruction symbol used in the program.
Instruction symbols are based on 16-bit instructions.
• Change the instruction symbols for 32-bit instructions as shown below.
32-bit instructions: Add a D to the start of the instruction.
Example
16-bit command
• Change the instruction symbol so that the start execution command is output when the signal is ON, as shown below.
Add a P to the end of the instruction that is executed only at the leading edge of OFF to ON.
Example MOV

Instruction executed during ON
3): Indicates the symbol diagram on the ladder.
MOV S
Indicates destination.
Indicates source.
Indicates instruction symbol.
Destination: Indicates the destination of the data after operation.
Source: Stores the data before operation.
108
Sequence program
Symbol
S D
MOV
S D
MOVP

3)
+ D+
32-bit command
MOVP
Instruction executed only at the leading edge of OFF to ON
D
Process Execution
description condition
(S)(D)
 
4) 5)

WAND S1 S2 D
Indicates destination.
Indicates source.
Indicates instruction symbol.
Number of
steps
5

6)