Memorex MHBT0545 User Manual

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within an
equilateral triangle is intended to alert the user to the presence of uninsulated
dangerous voltage within the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
ATTENTION: The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the appliance.
WARNING: Users of this product are cautioned not to make modifications
or changes that are not approved by MEM-CE, LLC., doing so may void the
compliance of this product and may result in the loss of the user's authority
to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique
de la classe B est conforme à la norme NMB-003 du Canada.
1. Do not disassemble, open, drop (mechanical 8. Do not cover. Do not use your device in the
abuse), crush, bend, deform, puncture, or rain or in/near any damp area.
shred. 9. Do not disassemble the device.
2. Do not modify or remanufacture, attempt to 10. In the event of battery leakage, avoid contact
insert foreign objects into the battery, immerse of the liquid with skin and eyes. If contact
or ex- pose to water or other liquids, or expose occurs, rinse affected areas with plenty of
to fire or excessive heat including soldering water and contact a physician.
WARNING
irons, or put in microwave.
3. Only use the battery with the charging system 1. Listening to music at high volumes for long
specified by the manufacturer/supplier. periods can lead to hearing problems. Using
4. Do not short-circuit the rechargeable battery these headphones at maximum volume for
or allow metallic or conductive objects to long periods of time is not recommended.
contact both internal battery. 2. To protect your hearing, turn down the volume
5. Only use the provided charger. Never use a of your music player before connecting your
damaged charger. headphones. After putting on the headphones,
6. Remember to charge the device before storing gradually turn up the volume until you reach a
for a long period of time. suitable level.
7. Do not leave your device in hot or cold areas 3. Avoid hazardous behavior that may cause
(car in direct sunlight or parked in a garage in an accident for you or somebody else
winter). Always store in area where temperatures (pedestrians, motorcyclists, drivers, cyclists)
remain consistent. The charger and the device or cause damage to property when you are
can become hot during charging. wearing your headphones.
IMPORTANT SAFETY INSTRUCTIONS
1. Read these Instructions. receptacles, and the point where they exit from
2. Keep these Instructions. the apparatus.
3. Heed all Warnings. 11. Only use attachments/accessories specified by
4. Follow all Instructions. the manufacturer.
5. Do not use this apparatus near water. 12. Unplug this apparatus during lightning storms or
6. Clean only with a dry cloth. when unused for long periods of time.
7. Do not block any of the ventilation openings. 13. Refer all servicing to qualified service personnel.
Install in accordance with the manufacturer's Servicing is required when the apparatus has
instructions. been damaged in any way, such as power-
8. Do not install near any heat sources such supply cord or plug is damaged, liquid has been
as radiators, heat registers, stoves, or other spilled or objects have fallen into the apparatus,
apparatus (including amplifiers) that produce the apparatus has been exposed to rain or
heat. moisture, does not operate normally, or has been
9. Do not defeat the safety purpose of the polarized dropped.
or grounding-type plug. A polarized plug has 14. WARNING: To reduce the risk of fire or electric
two blades with one wider than the other. A shock, do not expose this apparatus to rain or
grounding-type plug has two blades and a moisture. Do not place objects filled with water,
third grounding prong. The wide blade or the such as a vase, on the apparatus.
third prong are provided for your safety. When 15. The AC mains plug is used as the power
the provided plug does not fit into your outlet, disconnect device and it should remain readily
consult an electrician for replacement of the accessible and operable during intended use. In
obsolete outlet. order to completely disconnect the apparatus
10. Protect the power cord from being walked on from power, the mains plug should be completely
or pinched particularly at plugs, convenience removed from the AC outlet socket.
Wireless Headphones
Bluetooth
I'll Play Your Tunes
Congratulations on your purchase of the Memorex Bluetooth ® Wireless
Headphones! Built-in Bluetooth Wireless Technology and easy-access
controls keep you tuned in and chill with comfortable, rechargeable
headphones, and deep bass for enhanced sound. Recharge through
micro-USB as needed for 5-8 hours of playback time. Please follow these
operational instructions carefully. Save them for future reference.
HOW TO USE THE MEMOREX MHBT0545
RECHARGEABLE BATTERY
The MHBT0545 Bluetooth ® headphones feature a built-in Rechargeable
Battery that can be charged using the micro USB Charging Port and
cable (included). Before initial use, fully recharge the Headphones for
approximately 2-3 hours for about 5-8 hours of music playback or talk
time. To charge:
1. Turn on the headphones by pressing and holding the Power/Phone
button for 3 seconds; an audio tone will sound and the LED will blink
blue once and then it will repeatedly blink orange.
2. Connect charging cable (included) to a computer USB port or USB
power adapter with 5V supply.
3. The LED will turn off when the integrated battery is fully charged. When
the battery is low, the LED will blink rapidly every 12 seconds and a
tone will sound every minute.
OPERATION
Pairing a Bluetooth-Enabled Mobile Device
1. If pairing to a Bluetooth-enabled device for the first time, press and
hold the Power/Phone button for approximately 5 seconds, until the
LED blinks blue and orange alternately.
2. If previously paired, turn on MHBT0545 by pressing and holding the
Power/Phone button for 3 seconds. Once powered, the headphones
will automatically search for and pair to a previously paired Bluetooth
device.
3. Turn on your mobile device's Bluetooth option in settings to search for
a discoverable device with a Bluetooth signal. Select MRX-MHBT0545
from the device results on your smartphone or tablet.
4. You will hear an audible tone indicating the Bluetooth connection is
now enabled and the LED will blink blue rapidly when successfully
paired.
5. Use "0000" if a pairing code is necessary on your mobile device.
6. Find your music selection on your mobile device, select play and enjoy!
If connection is lost after successful pairing, check to make sure the
distance between headphones and Bluetooth-enabled device does not
exceed 33 ft/10 m. If the connection is interrupted due to low battery,
switch the headphones off, recharge the internal battery, and repeat steps
when fully charged.
Pairing Two Bluetooth-Enabled Mobile Devices
1. Turn off the Bluetooth function of the mobile device already paired to
the Bluetooth headphones.
2. Repeat the Pairing process according to the previous section with a
second Bluetooth-enabled mobile phone.
3. Once the second device is successfully paired, turn off the Headphones
by pressing the Power/Phone button.
4. Next, turn on the Bluetooth function of the first mobile phone, then turn
on the Bluetooth Headphones.
5. The Bluetooth Headphones will automatically connect to both mobile
phones.
Listen to Music
1. When the Bluetooth-enabled device is paired, you can use your mobile
device or these Headphones to play and pause music, skip tracks and
control volume. The sound will be heard through the Headphones.
2. You can also adjust the speaker volume level by pressing the Volume +
and – buttons.
3. Press the Skip Back/Redial 9 button to play Previous song, or Skip
Next : button to play Next song.
4. Press the Power/Phone button to Play or Pause Music.
HOW TO USE THE MEMOREX MHBT0545
5. Adjust EQ when playing music by pressing and holding the Skip Next
: button for 2 seconds then release; there will be a slight pause in the
music. This will select the next EQ mode and cycle as follows: Bass
Boost > Treble Boost > Default.
Answer a Phone Call
1. When there is an incoming call, the music will automatically pause. Pick
up the call by pressing Power/Phone button; press again to end the call.
2. To Redial the last called phone number, press the Skip Back/Redial 9
button twice if your portable device supports this function.
3. Reject an incoming call by pressing the Skip Next : button once.
4. Transfer calls between Bluetooth Headphones and your smartphone by
pressing Skip Next : button once.
Note: You are able to answer calls from two different phones when both
are connected via Bluetooth WiFi. When on a call from mobile phone 1,
and another call comes in from mobile phone 2, there will be a beeping
sound to let you know. Answer mobile phone 2 by pressing the Power/
Phone button twice. Press twice again to switch back to calling from
mobile phone 1. If the Power/Phone button is pressed once during a call,
it will hang up that device. The Bluetooth Headphones will automatically
switch back to the other mobile phone for the next incoming call on that
device.
5. Press Skip Next : button once again and the call will transfer back to
the Bluetooth Headphones.
LINE IN AUDIO JACK
1. Insert one end of the audio cable (included) into the Line Out Jack (or
Headphone Jack) on your external audio device and the other end into
the Line In Jack.
®
2. Use the connected external audio device to play and pause music.
Sound will be heard through the Headphones.
Note: When a mobile device and headphones are paired and connected
via Bluetooth WiFi and headphones are in Standby mode, you must
pull out the audio cable first, then pick up the call using the Bluetooth
Headphones.
3. Adjust the speaker volume level either by pressing the Volume + and
– buttons on the Headphones or by using the volume controls on the
mobile device.
TO TURN THE UNIT OFF
Press and hold the Power/Phone button for 3 seconds; the LED will blink
blue and orange once and then turn off.
AUTO OFF
The MHBT0545 will automatically shut off if there is no music from a Line In
source or from a Bluetooth-enabled device for more than 10 minutes.
ADJUST THE HEADPHONES / FOLD THE HEADPHONES
To adjust or fold, see the following illustrations:
RESET
To reset the unit, insert a paper clip or similar object into the Reset hole
for approximately 5 seconds.
User Guide
Please read these instructions completely
before operating this product.
MEMOREX-CE.COM
MHBT0545
LED INDICATOR
MODE LED EFFECT
Charging ........................................................................................ Solid Red
Fully Charged ...........................................................................................Off
Standby .............................................Blinks Blue 3 times every 12 seconds
Pairing ................................................... Blinks alternately Blue and Orange
Paired .............................................................................. Blinks Blue rapidly
Low Battery ................................... Blinks Orange rapidly every 12 seconds
LOCATION OF CONTROLS
1
4
2
5
3
6
8
7
9
10
1. Volume – Button 6. RST (Reset) Hole
2. Skip Back/Redial 9 Button 7. Microphone
3. Power/Phone (Play/Pause) Button 8. Micro USB Jack (for Charging)
4. Volume + Button 9. Line In Jack
5. Skip Next : Button 10. LED Indicator
SPECIFICATIONS AND COMPATIBILITY
Battery ....................................................................Polymer Lithium Battery
Charging Interface .......................................................................Micro USB
Charging Input ................................................................................5V / 0.5A
Charging Time ...............................................................................2-3 hours
Talk Time ........................................................................................12 Hours
Standby Time ...............................................................................150 Hours
Speaker .............................................................................................50 mW
Frequency Response .............................................................20 Hz-20 KHz
Compatibility ....................................................... Bluetooth version VER4.1
Range ...........................................................................................33 ft/10 m
Accessories ............................................USB Cable, Line In Cable, Manual
LIMITED WARRANTY
MEM-CE, LLC. warrants this product against defects for 90 days from the date of
original purchase. MEM-CE, LLC. shall not be responsible for any lost data or other
incidental or consequential damages related to this product. Some jurisdictions
do not allow limitations on how long an implied warranty lasts, or the exclusion
or limitation of incidental or consequential damages, so the above limitations or
exclusions may not apply to you. This limited warranty gives you specific legal rights,
and you may have other rights which may vary from one state, province or country
to another.
PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90 DAYS IN CASE
YOU NEED TO RETURN THIS PRODUCT TO YOUR PLACE OF PURCHASE OR
MEM-CE, LLC.
FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE,
PLEASE VISIT OUR WEBSITE AT:
WWW.MEMOREXSUPPORT.COM OR CONTACT CUSTOMER SERVICE:
For customers calling within the United States and Canada, call 1-855-982-2538
MEM-CE, LLC.
11485 Valley View Road, Eden Prairie, MN 55344 USA MEMOREX-CE.COM
Memorex and the Memorex logo are trademarks of Imation Corp and its affiliates.
The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by Mem-CE LLC. is under license. All other
trademarks are the property of their respective owners.
For additional setup, operating assistance or an electronic version of this user
manual, please visit www.MEMOREX-CE.COM