Advanced System Operations Menu
The Advanced System Operations Menu lists a variety of operational
settings and system status indicators. For most residential landscape
applications, the default settings will provide good results. Each setting
has a range of adjustment enabling its function to be tailored as preferred.
• Press and release the Menu
sequence shown in the table below.
Note:
If you step past a specific menu item, continue pressing the Menu
button to repeat the menu sequence.
Precision System Menu Item
System Calibration Mode
Watering Completion Time
Smart Bypass Timer
Freeze Shut-off Mode Temp
Signal Strength Indicator
Battery Voltage Indicator
Sensor Identification Code
Temperature Format Indicator °F
Sensor Temperature
• Where applicable, press the Plus
setting value.
• To exit the Advanced System Operations Menu, either press the Menu
button to display the Operating Mode screen or allow the receiver
to idle for 10 seconds and it will exit automatically.
8
button to step through the menu
Default Setting Range
Automatic
Manual Reset
4 Hours
0–24 Hours
24 Hours
1–199 Hours
39°F
35–45°F (2–7°C)
Review Only
0.0–10.0+
Review Only
0.0–4.5+
Review Only
00 00 00–99 99 99
°F or °C
14° F - 131° F
Review Only
(-10°C to +55°C)
or Minus
buttons to adjust the
System Calibration Mode
Enables the sensor system to be manually calibrated for
current maximum soil moisture content.
Watering Completion Time (0–24 Hours)
Determines the amount of time allowed for a watering
cycle to be completed before the Watering Restricted
mode takes effect.
Smart Bypass Timer (1–199 Hours)
Determines the amount of time the system remains in
Smart Bypass mode (and after Freeze Shut-off mode)
before returning to the Normal Operating mode.
Freeze Shut-off Mode Temp (35–45°F or 2–7°C)
Determines the temperature that initiates the Freeze
Shut-off mode to suspend watering operation.
Signal Strength
Indicates signal strength in a digital format.
Battery Voltage
Indicates total voltage output of the sensor batteries.
Sensor ID Code
The Sensor Identification Code is displayed in three
number pairs, accessed by repeatedly pressing the
Plus or Minus button.
Temperature Format
Enables temperature format to be displayed in degrees
Fahrenheit or Centigrade.
Sensor Temperature
Indicates the sensor temperature.