Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Focusrite RedNet D64R
Summary of Contents for Focusrite RedNet D64R
-
Page 1: User Guide
User Guide www.focusrite.com FA9096-06... -
Page 2: Table Of Contents
Focusrite RedNet Warranty and Service ........ -
Page 3: About This User Guide
About this User Guide This User Guide applies to both the RedNet 6 and RedNet D64R MADI Bridge interfaces. It provides information about installing each unit and how either can be connected into your system. All references relating to the RedNet 6 are also applicable to the RedNet D64R. In any instances where names or values differ, the screening or value for the D64R unit will be appended in square brackets, eg., “Power [PSU A]”. -
Page 4: Introduction
INTRODUCTION Thank you for purchasing the Focusrite RedNet 6/D64R. RedNet 6 RedNet D64R RedNet 6/D64R MADI Bridge is a 1U 19in rack-mount unit that provides an interface between any MADI (AES10) device and the RedNet Ethernet audio system. Support for up to 64 channels of digital audio I/O at standard sample rates (44.1/48kHz) from a MADI system –... -
Page 5: Installation Guide
INSTALLATION GUIDE RedNet 6/D64R Connections and Features Front Panels RedNet 6 RedNet D64R AC Power Switch Power Indicator(s) • Power [PSU A] – Illuminates when an AC input is applied and all DC outputs are present. • PSU B – Illuminates when an AC input is applied and all DC outputs are present. - Page 6 Front Panels . . . Continued RedNet 6 RedNet D64R MADI Input Indicators If a selected input signal is either invalid or not present the input source LED will flash. • COAXIAL – Orange LED, indicates that Coax is the selected input, or that AUTO is selected and the BNC input is valid.
-
Page 7: Rear Panels
AC ONLY 100 - 240V ~ 50/60 HZ 30VA MADI OPTICAL MADI COAXIAL WORD CLOCK ETHERNET WARNING THIS EQUIPMENT MUST BE EARTHED BY THE POWER CORD RedNet D64R Focusrite AC ONLY 100 - 240V ~ 50/60 HZ 30VA PUSH PUSH MADI OPTICAL MADI COAXIAL... -
Page 8: Power Connection
This information is only applicable to the RedNet D64R. IEC Power Cord Retaining Clip RedNet D64R is supplied with IEC power cord retaining clips. These prevents accidental disconnection of a power cord during use. When the unit is first installed, the retaining clips will need to be attached to power input sockets on the rear panel. -
Page 9: Physical Characteristics
Physical Characteristics 308mm / 12.13” 465.0mm / 18.3” 31.8mm / 1.25” RedNet 6/D64R dimensions are illustrated in the diagram above. RedNet 6/D64R requires 1U of vertical rack space and at least 350 mm of rack depth, to allow for cables. RedNet 6/D64R weighs 3.74 (4.32) kg and for installations in a fixed environment (eg., a studio), the front-panel mounting screws will provide adequate support. -
Page 10: Rednet 6/D64R Operation
RedNet 6/D64R unit or the computer on which RedNet Control is running, or by disconnecting either from the network. From time to time Focusrite will release RedNet firmware updates within new versions of RedNet Control. We recommend keeping all RedNet units up to date with the latest firmware version supplied with each new version of RedNet Control. -
Page 11: Madi Modes
MADI Modes RedNet 6/D64R supports both varispeed and non-varispeed MADI modes. Non-varispeed mode enables up to 64 channels I/O at 48 kHz. Varispeed mode enables up to 56 channels I/O at 48kHz. The MADI input of RedNet 6/D64R will automatically detect the channel count of incoming signals, meaning the user does not need to adjust any settings. -
Page 12: Pull Up And Pull Down Operation
Pull Up and Pull Down Operation RedNet 6/D64R is able to operate at a specified pull up or pull down percentage as selected in the Dante Controller application. When operating in 64-channel (ie. non-varispeed) mode, MADI is not capable of operating at greater than approximately ±1% of the nominal sample rate. -
Page 13: Other Rednet System Components
OTHER REDNET SYSTEM COMPONENTS The RedNet hardware range includes various types of I/O interface and PCIe/ PCIeR digital audio interface cards which are installed in the system’s host computer or in a chassis. All the I/O units can be considered as “Break-Out” (and/or “Break-In”) boxes to/from the network, and all are built in mains-powered, 19”... -
Page 14: Id (Identification)
ID (Identification) Clicking on the ID icon will identify the physical device being controlled by flashing its front panel LEDs. Tools Menu Clicking on the Tools icon will gain access to the following system settings: MADI Input Select – Only one can be selected at any time. •... -
Page 15: Appendix
APPENDIX Connector Pinouts Ethernet Connector Cat 6 Core Connector type: RJ-45 [etherCON] receptacle White + Orange Applies to: Ethernet (Dante) Orange White + Green Blue White + Blue Green White + Brown Brown... -
Page 16: Performance And Specifications
PERFORMANCE AND SPECIFICATIONS Sample Rate Converters Sample Rate Lock Range 41 to 216 kHz (MADI) Gain Error -0.01 dB Dynamic Range > 139 dB (-60 dBFS method) THD + N < -130 dB (0.00003%); 0 dBFS input Latency 43 to 196 samples (Network and MADI sample rate dependent) MADI Clock Sources RedNet, MADI Input and Word Clock Digital Performance... -
Page 17: Front Panel Indicators
Front Panel Indicators Power [PSU A] Green LED. Illuminates when an AC input is applied and all DC outputs are present PSU B Green LED. Illuminates when an AC input is applied and all DC outputs are present [D64R only] Green LED. - Page 18 Dimensions Height 44.5mm / 1.75” (1RU) Width 482.6mm / 19” Depth 308mm / 12.13” Weight Weight 3.74 [4.32] kg Power PSU[s] 1 [2] x Internal, 100-240V, 50/60Hz, consumption 30VA...
-
Page 19: Focusrite Rednet Warranty And Service
In the event of a Manufacturing Defect becoming evident in a product within 12 months from the date of the original purchase Focusrite will ensure that the product is repaired or replaced free of charge. A Manufacturing Defect is defined as a defect in the performance of the product as described and published by Focusrite.