Advertisement
Now start...
With washer in laundry area.
Pull the strap completely
out of the washer.
1
Read, then remove
label that
n
covers yellow shipping
strap and
power supply cord. Pull to completely
remove
the yellow shipping
strap with 2
cot-terpins
from the inside of the washer.
The power
cord is attached
to the
shipping
strap.
Pull firmly to remove
the other end of
shipping
strap from the back of the
washer. The shipping
strap plug must be
completely
removed
from the washer for
the self-leveling
legs to be released.
Save the shipping strap for use in Step 17.
Numbers
correspond to
steps.
2
n
Read, then remove
label that
covers power
cord and drain connector.
Peel the tape down
and off each side of
cabinet.
Use new hoses and washers that came
with your washer.
8
3
co$ing
washer
n
Insert a flat washer into
each
end
of the inlet hoses. Check that washers are
firmly seated
in couplings.
4 I II
III
n
Attach
hose to bottom
inlet valve
opening
first; then second
hose to top
inlet. Tighten
couplings
by hand.
Then
use pliers to make an additional
two-
thirds turn,
IMPORTANT: THIS PROCEDURE MUST BE
FOLLOWED TO ASSURE PROPER
INSTALLATION.
5
To prevent
the drain hose from
n coming
off or leaking,
it must be
installed
per the following
instructions:
1. Wet the inside end of the drain hose
with tap water.
DO
NOT USE ANY
OTHER LUBRICANT.
Pull the yellow
strap completely
out of the washer.
2. Squeeze
ears of clamp
with pliers to
open and place
clamp
over the
end of the drain hose.
3. While holding
clamp
open, work
end of drain hose onto drain
connector
until drain hose is within
l/4 inch (0.64 cm) of ribbed
stop.
4. When the end of the drain hose is
within
l/4 inch (0.64 cm> of ribbed
stop, position
clamp
on drain hose
so that the bottom
of the clamp
is
l/4 inch (0.64 cm) from the end of
the hose, release pliers.
1 IA"
clamp
and slide
over 'hook' end of
drain hose to
secure the rigid
and corrugated
sections together
Floor Damage
Slide washer onto cardboard
or
hardboard
before moving across floor.
Failure to do so may cause damage to
floor covering.
7
Move washer close to final position.
n Put "hook"
end of drain hose into
laundry
tub or standpipe.
Check for
proper length
of drain hose.
Panel B
Advertisement
