Humminbird ASETH5PXG Installation Manual

Download this manual

ETHERNET SWITCH Installation Guide

VERVIEW

The Ethernet Switch allows you to share sonar and navigation data from up to ﬁve Humminbird®

control heads.

NOTE: This accessory can only be used with Humminbird control heads that have Ethernet

capability. Contact Customer Service at humminbird.com or call 1-800-633-1468 for more

information.

REPARATION

Following are instructions for the installation of this accessory. Before you start installation, we

encourage you to read these instructions carefully in order to get the full beneﬁt from your

Humminbird accessory.

Supplies: In addition to the hardware supplied with your installation kit, you will need a powered hand

drill, a 9/64" drill bit, a Phillips screwdriver, a level, a pencil, and optional-purchase Humminbird Ethernet

cables.

Customer Service: To purchase cables, or if you have any questions about the installation, visit our Web

site at humminbird.com or call Customer Service at 1-800-633-1468.

NSTALLATION

Determining the Mounting Location

The Ethernet Switch is designed to mount on any ﬂat, level surface of your boat. Prior to installation,

you must ﬁrst determine where to mount the Ethernet Switch.

1. Use a level to locate a suitable, ﬂat area to mount the Ethernet Switch.

2. Place the Ethernet Switch in the desired mounting location and test the length of the Ethernet

cables (separate purchase required) to ensure that each cable will reach the Ethernet Switch.

Installing the Ethernet Switch

Once you have determined the mounting location, perform the following procedures to install the

Ethernet Switch on your boat.

1. Set the Ethernet Switch in place on the mounting surface. Mark the two mounting screw

locations with a pencil.

2. Set the Ethernet Switch aside, and drill the two mounting holes using a 9/64" drill bit.

NOTE: On fiberglass hulls, it is best to use progressively larger drill bits to reduce the

chance of chipping or flaking the outer coating.

Example of an Ethernet Network Configuration

531951-2_D

Installing the Ethernet Switch

Page 1 531951-2_D ETHERNET SWITCH Installation Guide VERVIEW The Ethernet Switch allows you to share sonar and navigation data from up to ﬁve Humminbird® control heads. Example of an Ethernet Network Configuration NOTE: This accessory can only be used with Humminbird control heads that have Ethernet capability.
Page 2: Connecting The Ethernet Cables
1b. If you need to wire the power cable directly to a battery, obtain and install an inline fuse holder and a 3 amp fuse (not included) for the protection of the accessory. Attach the black wire to ground (-) and the red wire to positive (+). Humminbird is not responsible for over-voltage or over-current failures.
Page 3 Service or visit our Web site to verify the ﬂat rate repair fee for your free of charge at Humminbird’s option and returned to the customer product (visit the Product Support section): freight prepaid.
Page 4 Web site humminbird.com either by phone or by email, to obtain a Repair Authorization Number for your unit. E-mail service@humminbird.com NOTE: Please do not return your Humminbird to the Telephone 1-800-633-1468 store for service. Direct Shipping Humminbird Please have your product model name and serial number available Service Department before calling the factory.