Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Juniper Manuals
  4. Control Unit
  5. IDP 8200
  6. Installing manual

Juniper IDP 8200 Installing Manual

I/o modules
Hide thumbs Also See for IDP 8200:
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual
Installing IDP 8200 I/O Modules
Date: June 27, 2008
Revision 00
1 Steps to Deploy a New IDP 8200 with New I/O Modules
This document provides instructions for installing IDP 8200 I/O modules.
Follow the workflow that applies to the stage of your deployment:
"Steps to Deploy a New IDP 8200 with New I/O Modules" on page 1
"Steps to Add or Replace I/O Modules in a Deployed IDP 8200" on page 3
When your Juniper Networks shipment arrives, it includes an IDP 8200 chassis with
4 blank I/O module trays installed. Separately, your shipment might include one or
more installable I/O module trays.
To install the I/O module hardware, follow these steps:
1. Install the IDP appliance in your equipment rack and connect the power supply,
as described in Chapter 4 of the Juniper Networks Intrusion Detection and
Prevention Installation Guide.
Carefully observe safety guidelines provided in the Juniper Networks
CAUTION:
Intrusion Detection and Prevention Installation Guide.
2. Power off the device. Verify that the POWER LED is off.
3. Unscrew the I/O module blank tray and remove it from the chassis.
Figure 1: Identifying the I/O Module Blank Tray
4. Carefully replace the blank tray with the new I/O module tray.
Steps to Deploy a New IDP 8200 with New I/O Modules
I/O Module
Blank Tray
1

Advertisement

loading

Related Manuals for Juniper IDP 8200

Summary of Contents for Juniper IDP 8200

  • Page 1 “Steps to Deploy a New IDP 8200 with New I/O Modules” on page 1 “Steps to Add or Replace I/O Modules in a Deployed IDP 8200” on page 3 1 Steps to Deploy a New IDP 8200 with New I/O Modules When your Juniper Networks shipment arrives, it includes an IDP 8200 chassis with 4 blank I/O module trays installed.
  • Page 2 10. Verify traffic flow, as described in Chapter 5 of the Juniper Networks Intrusion Detection and Prevention Installation Guide. 11. Add the sensor to NSM, as described in Chapter 6 of the Juniper Networks Intrusion Detection and Prevention Installation Guide.
  • Page 3 The steps provided in this section assume you have already installed IDP 8200 with one or more I/O modules and deployed the appliance to your network. Follow these steps to add or replace I/O modules to an IDP 8200 you have already deployed: 1.
  • Page 4 10. In NSM, use the Device Manager or Policy Manager to update the IDP policy and push it to the sensor. For details on using NSM, see the Juniper Networks Netscreen-Security Manager Administrator’s Guide and the NSM online help.

  • Page 5: Getting Help

    You must reboot the appliance before you can use the I/O module interfaces. NOTE: Rebooting the appliance disrupts network connections. If you have already deployed your IDP 8200 appliance to your network, choose an acceptable time to reboot. You can verify the patch has been installed by examining the IDP version file.
  • Page 6 Intrusion Detection and Prevention (IDP) 4.2 Juniper Networks, Inc. ATTN: General Counsel 1194 N. Mathilda Ave. Sunnyvale, CA 94089 U.S.A. www.juniper.net Getting Help...