Dvd; Dvd Codes; Programming With Code Search; Retrieving Codes - RCA RCU300 Product Manual

RCU300 Manual 12/11/01
Programming For DVD
Follow same instructions for programming VCR but use
DVD code list.
The DVD codes are
programmed using the
VCR/DVD key.
DVD Code List
Aiwa ......................................................350
Hitachi ..................................................351
JVC ..............................................161, 352
Konka ............................................353, 354
Magnavox ............................162, 356, 357
Mitsubishi ..............................................163
Panasonic ............................................355
Philips ..................................162, 356, 357
Pioneer ..................................................165
ProScan ................................................160

Programming With Code Search

If your TV, VCR, DVD, or Cable Box does not respond after you
have tried all the codes for your brand, or if your brand is not
listed, try searching for your code by following the steps below.
1. Turn on the device you wish
to program.
2. Press and hold CODE SEARCH
until the INDICATOR LIGHT
lights, then release CODE
SEARCH.
3. Press and release the device
button for the device you are
programming (TV, VCR/DVD or
DBS/CABLE). The INDICATOR
LIGHT will blink once then
remain lit.
4. Press and release OFF/ON until
your device turns off.
Important: You may have to press
OFF/ON up to 200 times.
5. When your device turns off,
press the ENTER button, the
INDICATOR LIGHT will go off.
9
11:51 AM Page 10
DVD CODE
RCA ......................................................160
Sanyo ....................................................359
Sony ......................................166, 360, 361
Toshiba..................................167, 362, 363
Zenith ....................................................364
INDICATOR
CODE
LIGHT
SEARCH
DBS/ VCR/
TV
CABLE

DVD

(BLINK)
OFF/ON
ENTER
(OFF)

Retrieving Codes

If you need to find the three-digit code for your TV, VCR, DBS,
DVD or Cable Box after your device is set-up using Code Search,
use this procedure.
1. Press and hold CODE SEARCH
until the INDICATOR LIGHT
lights, then release CODE
SEARCH.
2. Press and release the device
button for the device's code
you are retrieving (TV,
VCR/DVD, or DBS/CABLE).
The INDICATOR LIGHT will
blink once then remain lit.
3. Press and release CODE
SEARCH. The INDICATOR
LIGHT will turn off.
4. Starting with 0 on the keypad,
press the number buttons in
order (0-9) until the
INDICATOR LIGHT blinks.
5. The number which causes the
INDICATOR LIGHT to blink is
the first digit of your code.
6. Repeat step 4 until you have
retrieved all three numbers in
the code.
INDICATOR
CODE
LIGHT
SEARCH
DBS/ VCR/
TV
CABLE DVD
(BLINK)
CODE
SEARCH
(OFF)
(BLINK)
0 9
...
10