Table of Contents
Advertisement
Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels 2–13 appear in the TV's memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up and down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section below.
1.
Place channels in
memory (Autoprogram)
2.
Add or delete channels
Controls Alarm Adjust Setup
English Français Português
Autoprogram
Label: 13
Channel Memory: 13 Stored
Cable/Air: Cable
Controls Alarm Adjust Setup
English Français Português
Autoprogramming
Label: 13
Channel Memory: 13 Stored
Cable/Air: Cable
Controls Alarm Adjust Setup
English Français Português
Autoprogram
Label: 13
Channel Memory: 13 Stored
Cable/Air: Cable
Controls Alarm Adjust Setup
English Français Português
Autoprogram
Label: 13
Channel Memory: 13 Erased
Cable/Air: Cable
A. Hook up an antenna, cable
13
or components before you
begin these steps or you will
not be able to add channels
into memory.
B. Press MENU•PROG repeatedly
Clear
to select the Setup Menu and
highlight Autoprogram. This
menu is white.
C. Press MOVE
15
Autoprogram.
D. Press MOVE
TV adding all active channels
into memory.
E. Wait until the TV has cycled
through all the channels and
Clear
returns to the original channel.
A. Press MENU•PROG repeatedly
13
to select the Setup menu. This
menu is white.
B. Press MOVE
Channel Memory.
C. Press MOVE
Clear
channel number.
D. Select the channel number you
want to add or delete with the
number buttons.
13
E. Press MOVE
a channel (you will see Stored
on the screen when added and
Erased when deleted).
F. Repeat D and E for more
channels.
Clear
to highlight
to start the
to highlight
to underline the
to add or delete
19
Advertisement
Table of Contents
