Adjusting Roll Paper Width; Connecting A Serial Interface Cable - Epson TM-P60 Technical Reference Manual

2.7.5 Adjusting Roll paper width

The TM-P60 accommodates 58 mm {2.28"}, and 60 mm {2.36"} wide paper rolls. The roll paper
guide is removed to change the roll paper width to 60mm. The method of removing the guide is
following below.
1. Make sure the power is turned off.
2. Open the roll paper cover.
3. Take the roll paper guide off of the printer.
4. Release th hook to the direction (j in the illustration) by using a pointed tool, such as
tweezers or a small screwdriver, and lift up (k in the illustration) the roll paper guide to take
the roll paper guide off.
5. Set the memory switch (customize value) for the paper width. (See "2.7.3 Memory Switches"
(page 2-15))
Note:
When this printer connected with serial interface, the data length is always "8 bit." The handshake is
changed by a DIP switch; see "2.7.2 DIP switch" (page 2-14) for details.

2.7.6 Connecting a serial interface cable

When you aren't setting up the printer with a serial interface, omit this section and read from
"2.8.5 Confirming the connection between the host PC and printer" (page 2-28).
Use the following procedure.
1. Turn off the printer.
Rev. C
k
j
TM-P60 Technical Reference Guide
roll paper guide
hook
Setup 2-23