Table of Contents
Advertisement
.—
Two functions,
"Endless play" and "All-key lock",
can be
enjoyed by using the hold
function.
I
Endless play
I
This function will play back a tape to the end, rewind it then
replay it again, and again until you stop it.
In the stop or playback mode, press the (e) button.
The "Ho/d" indicator will flash.
Press the b PLAY button.
D
The "~" indicator will light, and endless play will start.
The tape is rewound to the beginning
and then playback will
start.
If the counter
memory function is used in combination with
endless play, the VCR will play
back the tape to the counter
reading "M
OHOOMOOS"then stafi again from the
beginning.
TO stop the endless play, press the (~),
STOp or
A EJECT button and the endless play function is
cancelled
and the VCR goes in the stop or eject
mode.
[
All-key lock
When the all-key lock function is engaged,
all the keys on the
remote control unit and on the VCR become inoperative.
Press
the (+
button.
If You wish to use the all-key lock function during
recording or playback, select first the function you want
to use before pressing the (b)
button.
Press the 11PAUSESTILL
button.
The all-key lock function is set and, the "~" and
"AL l-lold;'indicators
will light.
This VCR is highly sophisticated.
It is shipped from the factory
after having been checked and adjusted under the most rigid
quality
control and inspectionsystem. Should problems
occur,
check the following points.
Symptom
i
Check
flOhltS
~. "
~
Are the
connections
between your VCR
. Was tuning correctly preset?
Off the air
reception . The
w'deo channel setting of the TV
on the VCR Is poor
receiver
does not conespond to the video
channel presetting
of the VCR.
Playbackpicture
The
video channel setting of the TV
does
not appear
receiver
does not correspond to the
video
channel presetting of the VCR.
interference
In
Adjust the tracking control.
play back picture
Dust or dirt on video heads.
Take the VCR to an Authorized Service
Station or dealer.
No recording
l%e erasure-prevention tab on the cassette
has been removed.
Timer recording
Is
The starting day and time have not been
'
not possible
set correctly.
The clock time is not set correctly.
There has been a power interruption of
more than 60
minutes.
This VCR is a precision instrument
and, if treated with care, will
provide years of satisfactory
performance.
However, in the
event of difficulty, the owner is advised not to attempt to make
repairs or open the cabinet. Servicing should always be
referred to your servicing dealer or Authorized
Warranty
Station.
To cancel the all-key lock function, press the (-.-)
button.
Advertisement
Table of Contents
