HP 530SFP+ User Manual page 9

CAUTION:
If the server is not PCI Hot Plug compliant, power it down and disconnect the power cord from the
power outlet before removing the server access panel. Failure to do so may damage the adapter or
server.
Procedure
1. Power down the server.
2. Remove the power cord and server access panel.
WARNING:
To reduce the risk of personal injury from a hot component, allow the surface of the option card to
cool before touching it.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
3. Identify the PCIe expansion slot in which the adapter is to be installed. If a low-profile option slot is to be
used, install the low-profile bracket onto the adapter.
4. Remove the expansion slot cover from the PCI Express slot.
5. Firmly seat the adapter in the PCI Express slot. Figure 1: Adapter and PCI Express slot on page 9
shows the adapter and the PCI Express slot.
Figure 1: Adapter and PCI Express slot
NOTE:
For 1U type servers you may need to replace the standard profile bracket with a low-profile bracket.
For information about installing a low-profile bracket, see Installing a low-profile bracket.
6. Install the access panel, and then connect the power cord.
Installing an adapter 9