Samsung MAX-610 Service Manual page 64

Disassembly and Reassembly
3-5 CD Mecha Continued
*When removing, take extreme care not to damage the hook.
1. Open the Tray Disc Ass'y by turning the Gear-Load % towards "open", then remove
the Wire-Tray Q.
2. Remove two Tray-Stopper and tray.
3-5-1 Tray Disassembly
1. Remove the Tray-Roulette 3 from the Tray-Disc Ass'y 4 by releasing the hook.
2. Remove the PCB-Sensor Ass'y 5 from the tray by releasing the hook.
3. Remove the Worm-Motor Ass'y ) from the Tray-Disc Ass'y 4.
4. Remove the Cushion-Motor 1 from the Tray.
5. Remove the Gear-Roulette 2 from the Tray-Disc Ass'y 4 by releasing the hook.
3-5-2 Main Disassembly
1. Remove the Table-Chuck Ass'y 6 from the Base-Main by turning it.
2. Push the Slider-Cam ! towards right, then lift it up to remove.
3. Remove the Gear-Tray ^ from the Base-Main by releasing the fixed hook.
4. Remove the Gear-Converter & from the Base-Main by releasing the fixed hook.
5. Remove the Gear-Cam % from the Base-Main by releasing the fixed hook.
6. Remove the Belt @ from the Pulley-Motor Ass'y 7 & the Gear-Pulley #.
7. Remove the Gear-Pulley # from the Base-Main by releasing the fixed hook.
8. Remove the Gear-Load $.
9. Remove the Gear-Synchro *.
10. Desolder two soldering points of the CD SUB PCB, then remove it from Base-Main by
releasing the hook.
11. Remove the Pulley-Motor Ass'y 7 by releasing the hook.
12. Remove the PCB-SW Ass'y 8 by releasing the hook.
3-5-3 CD Main PCB Disassembly
1. Remove the Lever-Lifter 9 from the Base-Main by releasing two hooks.
2. Remove four Rubber-CD 0 from the Lever-Lifter and then remove the Deck-CD ".
3. Remove the Hook.
4. Remove the CD MAIN PCB with the soldering iron.
Samsung Electronics 3-5