To Set Up - Coleman 2302-A Instruction Manual

UNPACKING THE PRODUCT.
Unpack your new water heater from the carton and make sure that all of the parts are included. If you find that one of the components is missing, please
contact Coleman for a replacement: 1-800-835-3278 or TDD: 316-832-8707. Make sure to remove the protective film on the display panel on the front of the
heater before use.
5-Gallon (19 L) Collapsible
Water Carrier
Pump Assembly
CHARGING THE BATTERY
1. Charge the battery before using your water heater for the first time.
2. Turn the main power switch to "OFF" position (available on model
2302-A only)
3. (Fig. 1) Remove the rubber flap covering the charging port.
4. Plug either 12 Volt Auto Recharger Cord or 120 Volt Household
Recharger Cord into unit and the power source.
5. See indicator chart for battery status / charging status.
NOTE: Please charge the battery for 6 hours at the first time to
maximize the performance of the battery.
CLEANING THE PRODUCT
Clean before first use. It is strongly recommended that you clean the heater prior to using for the first time. Follow the simple steps on page 7 before you leave
home, and then clean at least once a year or when the hose becomes discolored with a white calcium build up.

To Set Up

Select a level, sturdy surface for your water heater. A picnic table or camp table is ideal. Do not operate Hot
Water on Demand unit from a position directly on the ground. (This allows water to drain, preventing damage
TM
while the unit is off in freezing temperatures.)
Fill the 5-gallon (19 L) collapsible water container with water. The product may use water from a lake or stream,
but make sure that there's no debris or sand in the water, which may clog the water system and damage the
product. It's recommended to use a piece of cloth as filter to cover the opening of the water carrier before
filling in water.
SHOWER HEAD CONNECTION (FIG. 2)
• Shower end: threaded connector
Screw the threaded connector on the shower hose onto the end
of the shower.
• Heater end: sleeved connector
A - Pull up & hold the sleeve on the connector.
B & C - While holding the sleeve, push the connector into water outlet
until it stops.
D - Release the sleeve and the connector is locked.
IMPORTANT: To unplug the shower hose from the heater, pull up the sleeve to
unlock first, while holding the sleeve, pull out the connector.
4
12 Volt Auto Recharger Cord
(Located in storage compartment
of the appliance)
Shower Hose
Fig. 1
120 Volt Household Recharger Cord
(available on model 2302-A only,
located in storage compartment)
Mesh Hose Carrybag
Fig. 2
A
C
Shower Arm
Shower
(varies by model)
1
OFF
2
B
D